Customer Care / Training & Vendor Development / Content Creation Team
Condential - Copyright © 2006 NOKIA Only for training purposes Version: 1.0 | 11.06.2006 | 2610 | Board version: 1JV_30a | | Page 1(6)
Service Schematics
Exploded view and component disposal
Introduction
RH-86
Important:
This document is intended for use by authorized service centers only.
“Service Schematics“ was created with focus on customer care.
The purpose of this document is to provide further technical repair information for
NOKIA mobile phones on Level 3/4 service activities.
It contains additional information such as e.g. “Component nder”,
“Frequency band table” or “Antenna switch table”.
The “Signal overview” page gives a good and fast overview about the most
important signals and voltages on board.
Saving process time and improving the repair quality is the aim of this document.
It is to be used additionaly to the service manual and other training
or service information such as Service Bulletins.
All measurements were made using following equipment:
Nokia repair SW : Phoenix version 2006.04.6.130
Oscilloscope : Fluke PM 3380A/B
Spectrum Analyzer : Advanced R3162 with an analog probe
RF-Generator/GSM Tester : Rhode & Schwarz CMU 200
Multimeter : Fluke 73 Series II
While every endeavour has been made to ensure the accuracy of this document, some
errors may exist. If the reader nds any errors, NOKIA shall be notied in writing.
Please send E-Mail to: training.sace@nokia.com
Copyright © NOKIA
This material , including documentation and any related computer programs is protected
by copyright, controlled by NOKIA. All rights are reserved. Copying, including reproducing,
modifying, storing, adapting or translating any or all of this material requires the prior
written consent of NOKIA. This material also contains condential information, which may
not be disclosed to others whitout the prior written consent of NOKIA.
Table of contents
Frontpage
Frontpage 1
UI &Audio 2
UEM, UPP & Combo memory 3
RF-part 4
Signal overview 5
Component nder 6