NETGEAR ProSafe 802.11g
Wireless Access Point
WG302 Reference Manual
NETGEAR, Inc.
4500 Great America Parkway
Santa Clara, CA 95054 USA
202-10008-04
April 2006
Technical Support
Please register to obtain technical support. Please retain your proof of purchase and warranty information.
To register your product, get product support or obtain product information and product documentation, go to
http://www.NETGEAR.com. If you do not have access to the Wo rld Wide Web, you may register your product by
filling out the registration card and mailing it to NETGEAR customer service.
You will find technical support information at:
h
ttp://www.NETGEAR.com/ through the customer service area. If you want to contact technical support by
telephone, see the support information card for the correct telephone number for your country .
© 2006 by NETGEAR, Inc. All rights reserved.
Trademarks
NETGEAR and the NETGEAR logo are registered trademarks, and ProSafe is a trademark of NETGEAR, INC.
Windows is a registered trademark of Microsoft Corporation. Other brand and product names are trademarks or
registered trademarks of their respective holders. Information is subject to change without notice. All rights reserved.
Statement of Conditions
In the interest of improving internal design, operational function, and/or reliability, NETGEAR reserves the right to
make changes to the products described in this document without notice. NETGEAR does not assume any liability that
may occur due to the use or application of the product(s) or circuit layout(s) described herein.
Modifications made to the product, unless expressly approved by Netgear, could void the user’s authority to operate the
equipment. NETGEAR does not assume any liability that may occur due to such condition.
Federal Communications Commission (FCC) Compliance Notice:
Radio Frequency Notice
ProSafe 802.11g Wireless Access Point WG302
Tested to Comply
with FCC Standards
FCC ID: PY3WG302
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired
operation.
ii
FOR HOME OR OFFICE USE
v4.0, April 2006
Placement and Range Guidelines
Indoors, computers can connect over 802.11 wireless networks at a maximum range of 500 feet (152.4 m) for 802.11b
devices. However, the operating distance or range of your wireless connection can vary significantly, based on the
physical placement of the wireless access point.
For best results, identify a location for your wireless access point according to these guidelines:
• Away from potential sources of interference, such as PCs, large metal surfaces, microwaves, and 2.4 GHz cordless
phones.
• In an elevated location such as a high shelf that is near the center of the wireless coverage area for all mobile
devices.
Failure to follow these guidelines can result in significant performance degradation or inability to wirelessly connect to
the wireless access point.
To meet FCC and other national safety guidelines for RF exposure, the antennas for this device must be installed to
ensure a minimum separation distance of 20cm (7.9 in.) from persons. Further, the antennas shall not be colocated with
other transmitting structures.
FCC Statement
DECLARATION OF CONFORMITY
4500 Great America Parkway
Santa Clara, CA 95054, USA
declare under our sole responsibility that the product(s)
WG302 (Model Designation)
802.11g Pr oSafe Wireless Access Point (Product Name)
complies with Part 15 of FCC Rules.
Operation is subject to the following two conditions: (1) this device may not cause harmful interfe rence, and (2) this
device must accept any interference received, including interference that may cause undesired operation.
We Netgear,
Tel: +1 408 907 8000
FCC Requirements for Operation in the United States
Radio Frequency Interference Warnings & Instructions
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to rad io communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try and correct the interference by one or more of the following measures:
• Reorient or locate the receiving antenna.
• Increase the separation between the equipment and receiver.
v4.0, April 14, 2006
iii
Loading...