Netgear AG711T, AG711F Quick Start Manual

™

Gigabit Ethernet Modules AG711T/AG711F

The modularity of the FS726 and 750 Switches provides you with a highly
adaptable network. You not only can configure your network for copper and/or
fiber gigabit uplinks, but you also can opt to expand your network gradually
and affordably, as needed.

Installing a Gigabit Ethernet module:

1. Unscrew and remove the module cover plate.

2. Insert the module into the slot, pressing firmly to seat the module.

3. Tighten the module screws.

4. Press the reset button if the power has remained on throughout the installation 
of the gigabit modules.

M1-AG711-0

Trademarks

NETGEAR is a registered trademark of NETGEAR, Inc., in the
United States and other countries. All other trademarks and
registered trademarks are the property of their respective owners.
All rights reserved.

Statement of Conditions

In the interest of improving internal design, operational function,
and/or reliability, NETGEAR reserves the right to make changes to
the products described in this document without notice. NETGEAR
does not assume any liability that may occur due to the use or
application of the product(s) or circuit layout(s) described herein.

Certificate of the Manufacturer/Importer

It is hereby certified the NETGEAR Model AG711T and AG711F
Product Description has been suppressed in accordance with the
conditions set out in the MBPT-AmtsblVfg 243/1991 and Vfg
46/1992. The operation of some equipment (for example, test
transmitters) in accordance with the regulations may, however,
be subject to certain restrictions. Please refer to the notes in the
operating instructions. Federal Office for Telecommunications
Approvals has been notified of the placing of this equipment on
the market and has been granted the right to test the series for
compliance with the regulations.

EN 55 022 Declaration of Conformance

This is to certify that the NETGEAR Model AG711T and AG711F
Product Description is shielded against the generation of radio
interference in accordance with the application of Council Directive
89/336/EEC, Article 4a. Conformity is declared by the application
of EN 55 022 Class A (CISPR 22)

™

FCC Compliance Notice: Radio Frequency Notice

Federal Communications Commission (FCC) Compliance Notice:
Radio Frequency Notice
This device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions:

- This device may not cause harmful interference.

- This device mush accept any interference received, including 
interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with
limits for a Class A digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a commercial
installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference
to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference, in which
case users will be required to take whatever measures may be
necessary to correct the interference at their own expense.

Warning/Logo

Warning: This is a Class A product. In a domestic environment,
this product may cause radio interference, in which case the user
may be required to take appropriate measures.

Specifications

AG711T: IEEE802.3ab 1000BASE-T Gigabit Ethernet
AG711F: IEEE802.3z 1000BASE-SX Gigabit Ethernet