Minoura RS-1200 User Manual

Support Arm

Seat-tube

RS-1200 instructions manual

Thank you for purchasing the Minoura RS-1200 bicycle repair stand.

The RS-1200 is a stand for basic bike maintenance and repair work. It supports your bike at a height that allows easy access. The bike is supported at 3 positions; the bottom bracket shell, the down-tube and the seat-tube. The angle of the down-tube support arm and the seat-tube support hook position are adjustable to insure a perfect fit to your frame. The frame is also foldable for easy storage when it is not in use.

Please read this instructions carefully before use.

HOW TO ASSEMBLE RS-1200

Down-tube

Seat-tube Support

Support Hook

1 Install the step-bar tubes to the frame and the leg. (see Fig. A)

2Install the down-tube support arm to the main frame, then screw the knob bolt to the hole on the arm bracket.

3Open the seat-tube stay and insert the seat-tube support hook and plug in the end-cap.

BB Support	Front Wheel
	Support Stay
Frame	Arm Angle
	Adjust Knob
Leg

HOW TO MOUNT YOUR BIKE ON RS-1200

Use RS-1200 ONLY on a flat and stable

!

floor in order to prevent accidents.

Step-bar

(Fig. A)

1 Open the seat-tube support arm fully and set the left side crank arm towards the front

				wheel..
				Place the BB shell onto the BB support,
			2
				lean the bike backward until the seat-tube
				touches the hook, then adjust the down-
				tube support arm angle by turning the knob
				bolt.
						TIPS
					If	the brake or shifter cable is routed
					under or beside the down-tube and is
(Fig. B)					pinched between the frame and the
					bracket, use the supplied adapter.
MINOURA JAPAN		MINOURA NORTH AMERICA
1197-1 Godo, Anpachi, Gifu 503-2305 JAPAN		(for North American residents only)
Phone: [phone] / Fax: [phone]		1996 East Avenue, Hayward, CA 94541 U.S.A.
Email: [e-mail] / http://www.minoura.jp		Fax: [phone] / Email: [e-mail]