HyperMag ALU-LW series indoor bicycle trainer
instructions manual
- 1 -
SCHEMATIC
F-8
HF-7
M8-3
HM-11
HM-12
HM-2
HM-8
HM-9
HM-13
LM-13
F-4 F-2 |
F-4 |
F-9
F-1
F-7
HF-4
M8-3
HM-14
HM-3
HM-7
HM-4 / HM-5
F-1 |
: |
Coupling (Right) |
HM-2: |
Flywheel Side Inner Case |
F-4 |
: |
Coupling Cover (move side) |
HM-3: |
Mag Side Inner Case |
F-7 |
: |
Hub Handle (3/8” thread) |
HM-4: |
Dial Outer Cover |
F-8 |
: |
Wheel Position Adjust Knob |
HM-5: |
Remote Outer Cover |
F-9 |
: |
Hub Nut Protector (Grommet) |
HM-7: |
Alloy Rotor |
HF-4 : |
Rubber Foot Cap (35mm) |
HM-8: |
Axle w/ Bearings |
|
HF-7 : |
HyperMag ALU-LW Main Frame |
HM-9: |
Connection Plate |
|
M8-3 : |
Rubber Frame Cap (38.1mm) |
HM-11 : |
Flywheel Cover (yellow) |
|
LM-13 : |
Foot Pedal |
HM-12 : |
Flywheel (1,200 g) |
|
|
|
|
HM-13 : Base Platel |
|
|
|
|
HM-14 : |
Mag Fitting Bracket |
- 2 -
IMPORTANT NOTES
•Read all instructions carefully before use.
•Some assembly required.
•Keep the manual handy at all times.
•Do NOT use trainer for any other purpose than instructed.
•The trainer is manufactured to precise standards. You may not disassemble or rebuild it.
•"Magturbo" is the trademarks of Minoura Co.,Ltd. and may not be copied.
WARNINGS
!Use two-wheeled bicycles only. Tandems may be used if balanced correctly.
Replace your quick release skewer with the one supplied and install the coupling protector cap on
!to the right side coupling of the trainer. Otherwise the stability will not be guaranteed.
!Remove the coupling protector cap when you use your own quick release skewer.
!Remove all oils and moisture from the drive roller and the tire before use.
!Keep both hands on handlebars at all times and maintain a normal riding position.
Check the couplings supporting the rear hub for damage and cracks.
!Accidents may occur from cracked or damaged couplings. (Fig. A)
! |
You should not tighten the wheel axle by tightening the left side knob. |
(Fig. A) |
|
This is for pre-adjusting the wheel position to the exactly center of the |
|||
|
|
||
|
drive roller only. Securley tightening your bike to the trainer should be |
|
|
|
done with the right side hub handle only. |
|
!When using the trainer, place it on a flat surface for safe training.
Do not over tighten the hub-clamp handles. Over-tightening may cause damage to the trainer or
!bicycle frame. The clamp handles should be a snug and secure fit. Do not force!
!Before use, make sure all bolts and nuts are securely fastened.
Keep away from small children, and keep hands and feet away from spinning rollers and wheels at
!all times.
!Open the legs fully to get maximum stability.
- 3 -
Loading...