Installation Plan
Professional Dishwasher
PG 8056
Mat. no.: 10 251 400
en - US
Installation instruction
Observe installation instructions when installing machine.
This dishwasher is suitable for residential and commercial use.
Installation |
Installation should only be carried out by authorized installers in |
|
accordance with valid regulations, relevant standards and health and |
|
safety codes! |
Condensate |
Only use commercial grade cabinetry in the vicinity of this dishwasher |
|
as condensate may otherwise cause damage. |
Machine feet |
To ensure stability install the included floor bracket BBF-80 (Installation |
|
Instructions Mat.no.: 09788890) |
Electrical |
It is recommended to make electrical connection via a plug and socket |
connection |
so that electrical safety checks can be carried out easily. The socket |
|
must be accessible after machine installation. |
|
With a fixed installation, this must be via a main switch to be provided |
|
on site, which must completely isolate the machine from the power |
|
supply with a contact gap of at least 1/8’’ (3 mm). |
|
If necessary, an equipotential bond with good contact connection must |
|
be provided in accordance with all appropriate national and local |
|
regulations. |
|
Protection class IP21 |
Non-return device |
Connection to a drinking water supply is permitted without |
|
an additional non-return device. |
External dosing |
Connect up to two dosing systems at the rear panel for liquid cleaning |
system (optional) |
agent and rinse aid. |
page 1 / 6 |
Installation plan PG 8056 |
|
|
|
Dimensions in drawings in inches & [mm] |
|
|
|
|
EL |
Electrical connection |
WW |
Hot water |
KW |
Cold water |
AW |
Drain water |
|
|
|
|
DS |
External dosing connection (optional) |
|
|
|
|
|
|
Installation plan PG 8056 |
page 2 / 6 |