McIntosh C2300 User Manual

2A
C2300 Rear Panel Connections
MAIN OUTPUTS send signals to a Power Amplifier
MAIN OUTPUTS (Balanced) send signals to a Power Amplifier
OUTPUTS 1 and 2 send signals to Power Amplifiers and are switched On/Off with the Front Panel Output 1 and 2 Push-Buttons or Remote Control Push-Buttons
OUTPUTS 1 and 2 (Balanced) send signals to Power Amplifiers and are switched On/Off with the Front Panel Output 1 and 2 Push-Buttons or Remote Control Push-Buttons
SRVR OUT sends signals to the input of a recording device
CDR, CD, D/A and DVD IN PUTS (Balanced) accept high level program source signals
-
SRVR, CDR, CD, D/A, DVD and TUNER INPUTS accept high level program source signals
GND terminals accept a ground wire from a turntable
Connect the C2300 power cord to a live AC outlet. Refer to in­formation on the back panel of your C2300 to determine the correct voltage for your unit
Main Fuse holder, refer to information on the back panel of your C2300 to determine the correct fuse size and rating
MAIN POWER CONTROL Out put sends a turn-on signal to a McIntosh Component when the C2300 is turned on
-
POWER CONTROL ACC sends Turn-On signals to McIntosh Source Components when the C2300 is On. OUTPUT 2 and OUTPUT 1 send Turn-On signals to McIntosh Power Amplifier(s) when activated. POWER CONTROLS ACC, OUTPUT 2 and OUTPUT 1 may be re-assigned as TRIGGERS A - C to send Turn-On signals when a desired Input Source is selected
PASSTHRU Power Control Input receives a turn-on signal from a McIntosh Home Theater Controller
EXT SENSOR con nector permits the connection of a Mc­Intosh IR Sensor for remote operation
DATA PORTS send
­signals to McIntosh Source Components to allow control with the C2300 Remote Control
PHONO MM accepts signals from a Mov ing Magnet Phono Cartridge
-
PHONO MC accepts the low level signals from a Moving Coil Phono Cartridge
McIntosh Laboratory, Inc. 2 Chambers Street Binghamton, New York 13903-2699 Phone: 607-723-3512 FAX: 607-724-0549 Part No. 04106100
2B
Note: Refer to the C2300 Owner’s Manual page 9 for additional connection information.
C2300 Connection Diagram 3
Connection Legend:
Data Cable*- Digital Signal Cable ­ Sensor/Keypad Cable - RS232 Cable ­ Power Control Cable* - Ground Wire ­ Audio Signal Cable - AC Power Cords - Video Signal Cable - Loudspeaker Cable ­ RF Signal Cable - *
2 conductor shielded with 1/8 inch stereo mini phone plug on each end.
McIntosh Power Amplifier (Left Channel) - Main Room
(Partial View)
McIntosh A/V Control Center
Connect to AC Outlet
McIntosh Power Amplif ier (Right Channel) - Main Room
(Partial View)
McIntosh Laboratory, Inc. 2 Chambers Street Binghamton, New York 13903-2699 Phone: 607-723-3512 FAX: 607-724-0549
Connect to AC Outlet
Loading...