McIntosh C-1000-T Owners manual

C1000T

PREAMPLIFIER

C1000T

PREAMPLIFIER

CONTENTS

Performance Specifications........................................ 2

Notes ......................................................................... 2

Rear Panel.................................................................. 3

Section Location ........................................................ 3

Block Diagram........................................................... 4

Interconnection Diagram ...................................... 5 - 6

Main Left Schematic and PCB............................ 7 - 18

Main Right Schematic and PCB ........................ 19 - 30

Phono MC ........................................................ 31 - 32

Balance I/O Left Schematic and PCB ................ 33 - 34

PRELIMINARY

SERVICE MANUAL

Balance I/O Right Schematic and PCB .............. 35 - 36

Balance Switching Left Schematic and PCB ...... 37 - 38

Balance Switching Right Schematic and PCB.... 39 - 40

Meter Schematic and PCB ................................. 41 - 42

Headphone Schematic and PCB ....................... 43 - 44

Integrator Schematic and PCB.................................. 45

Parts List ............................................................ 47 - 56

Exploded View and Parts List............................. 57 - 58

Repacking Instructions ............................................. 61

PERFORMANCE SPECIFICATIONS

Power Requirements

100 Volts, 50/60Hz at 120 watts 110 Volts, 50/60Hz at 120 watts 120 Volts, 50/60Hz at 120 watts 220 Volts, 50/60Hz at 120 watts 230 Volts, 50/60Hz at 120 watts 240 Volts, 50/60Hz at 120 watts

Note: Refer to the rear panel of the C1000 Controller for the correct voltage.

General Specifications Overall Dimensions

C1000C: Width is 17-1/2 inches (44.45cm) Height is 6 inches (15.24cm) including feet Depth is 24 inches (61.0cm) including the Front Panel, Knobs and Interconnect Cables

C1000P: Width is 17-1/2 inches (44.45cm) Height is 6 inches (15.24cm) including feet Depth is 24 inches (61.0cm) including the Front Panel and Interconnect Cables

C1000T: Width is 17-1/2 inches (44.45cm) Height is 6 inches (15.24cm) including feet Depth is 24 inches (61.0cm) including the Front Panel and Interconnect Cables

Weight

C1000C - 39.0 pounds (17.7 kg) net

61.4 pounds (27.9 kg) in shipping carton C1000P - 33.0 pounds (15.0 kg) net

53.6 pounds (24.3 kg) in shipping carton C1000T - 34.0 pounds (15.4 kg) net

54.6 pounds (24.8 kg) in shipping carton

Interconnect Cables are supplied with the C1000 Preamplifier and C1000 Tube Preamplifier. They are used to connect Preamplifier(s) to the C1000 Controller.

1. The heavy notes on the schematic denote the primary signal path.

2. Unless otherwise noted, all voltages indicated on the schematics are measured under the following conditions: a. AC input at 120 volts, 50/60Hz. b. All voltages are +/-10% with respect to ground. A

high impedance (10 megaohm) voltmeter must be used.

3. Unless otherwise specified: a. Resistor values are in ohms. b. Capacitor values are microfarads (uF). c. Inductor values are in microhenries (uH).

NO TES

4. On PC board drawings, Square pad indicates: a. Polarized Capacitors - Positive b. Diodes - Cathode c. Others - Pin 1

5. WARNING Parts marked with the symbol have critical characteristics. Use only replacement parts recom mended by the manufacturer.

6. Use McIntosh Remote Control Model HR052 with the MVP861.