Maxdata 520, 220 installation guide

MAXDATA PLATINUM 520/220
Installation Guide for the Rack-Mount Slide Rail Kit

Parts List

The following is a list of all the parts that are relevant for installation; each part is designated with a
letter that is used in the installation guide.

External Rail

Middle Rail

Internal Rail

The middle rail (B) is slid
inside the external rail (A)
and the internal rail (C) in
turn is inside the middle rail
(B).

End Bracket

Round head screw, large

Round head screw, small

Nut

Perforated Plate with
threaded holes

 NOTE

Countersunk screws are not required.

Tip: Customers with a MAXDATA rack can simplify installation of the server by taking the screws,
washers, and clamping nuts from the fastening set of their cabinet.

1MAXDATA PLATINUM 520/220

Installation

1. Pull the internal rail (C) out of the middle rail (B).

2. Leave the middle rail (B) inside the external rail (A).

3. Measure the distance between the front and rear breadboard section of your cabinet. At-tach
the silver end brackets (D) to the external rail (A) with two screws (E) and two nuts (G) each.
Be careful to make sure that the distance between the fastening bracket for the external rail
(A) and the end bracket (D) is the same as the distance between both bread-board sections of
your server cabinet.

2 Installation Guide for the Rack-Mount Slide Rail Kit