Marantz Mount 12 User Manual

MOUNT12

Projector Mount

INSTALLATION INSTRUCTIONS

 Step 1

Invert the projector and place it on a soft and flat surface. Locate the three (3) 6 (mm) mounting points found on the bottom of the projector. Secure the two (2) Quick release sleeves (C) with the two (2) 6 (mm) x 20 (mm) Phillip Screws (B) (supplied). Align the keyhole openings from the mounting bracket (A) to the sleeves (C) and secure the bracket with the 6 (mm) x 12 (mm) knurl knob (D) (supplied). Do not over

tighten!

See Figure 1

 Step 2

Install the base box securely to the ceiling structure in accordance with proper commercial standards. Use (commercially available) suitable hardware depending on the installation requirements.

: If the (Optional) EXT81 adjustable height suspension

NOTE

adapter is a part of the installation, securely install the ceiling

adapter to the ceiling at this time.

(Refer to its Installation Instructions)

 Step 3

Install the two (2) conical spacers (L) and two (2) flat washers (K), two (2) hinge screws (J) loosely on both sides of the base box (H). Raise the projector with the mounting bracket attached and slip though the hinge pin slots openings on the bracket into the base box. Install the two (2) angle locking screws (I) adjust the angle, lock it, and then tighten the hinge pin screws. See Figure 2

 Step 4

Check all the hardware for proper tightness and security. Do not over tighten hardware.

PORTABLE PROJECTORS

(1) Remove the knurl knob screw and hold the projector with

two hands. (2) Slide it backwards to detach the sleeves from the keyholes. (3) Reverse the process for quick reinstall.

 Step 5

Raise the projector with the mounting bracket (E) and slip through the hinge pin slot openings on the bracket into the base box (H). Loosely install the two (2) hinge pin screws (J), conical spacers (L) and flat washers (K) and the angle locking screws (I). Adjust the angle and lock it. Then tighten the hinge pin screws (J). Do not over tighten See Figure 3

Check all hardware for proper tighten and security.

-_LA 061801_-

The ceiling should be capable of supporting a weight of

at least five (5) times the projector(s) or monitor(s)weight.

If it cannot, the ceiling must be reinforced. Proper

installation procedure by qualified personnel as outlined

in the installation instructions must be adhered to.

Failure to do so could result in serious personal injury.

DESCRIPTION/HARDWARE

A. MOUNT12 Mounting Bracket (1ea) B. 6 (mm) x 20 (mm) Phillip Screws (2ea) C. 6 (mm) Quick Release Sleeves (2ea) D. 6 (mm) x 12 (mm) Knurl Knob (1ea) E. Projector (Not Supplied) F. Ceiling Structure (See Warning Label) G. Suitable Hardware (Commercially Available) H. PBB-10RL Base Box/Jam Screw (1ea) I. 6 (mm) x 12 (mm) Angle Locking Screws (2ea) J. 6 (mm) x 12 (mm) Hinge Pin Screws (2ea) K. Flat Washers (2ea) L. Conical Spacers (2ea)

M. EXT81 Adjustable Suspesion Adapter (Optional)

N. Suspension Adapter Ajustable Pins (2ea)

For further information or ordering assistance

on the front of this page.