Mamiya Leaf Aptus II 8 User Manual

Leaf Aptus II 8
Users Guide
The Leaf Aptus II 8 is a medium format digital back with a sensor size of 44x33mm with an active pixel count of 7,312 X 5,474 making it a 40 megapixel size.
This back has a built in adapter to making it compatible with Hasselblad V series mounts. It mounts to the Hasselblad 500 series cameras the same as the Phase One H5.
Overall view! ! ! !
!!!!!!!!!Left View
!!!!!!!
1
Leaf Aptus II 8
Users Guide
!!!!!!!!
Bottom View! ! ! ! ! ! ! ! Sensor
! ! ! ! ! ! ! Adapter plate for Phase One Sliding ! ! ! ! ! ! ! back.! !!!!!!!
Line feet of adapter up with slots on bottom of back.
2
Leaf Aptus II 8
Users Guide
Rock back onto adapter plate! ! ! ! Slide latch to capture tabs
! Attaching back to adapter that is already ! installed on the sliding back
Adapter plate on sliding back
3
Leaf Aptus II 8
Users Guide
Attaching Firewire 800 cable to the digital back. The cable attaches to the bottom of the back and must be attached before attaching the back to the sliding back. Line up the silver mark on the Firewire 800 plug with the silver mark on the digital back. It is important to not attach the plug in any other way than just described, physical and electrical damage will occur.
4
Leaf Aptus II 8
Users Guide
Cable connections for view camera use. Install the coiled cable between outlet on back right with lens pc post. Sync cord or Pocket Wizard attaches to PC socket on back left.
5
Leaf Aptus II 8
Users Guide
Two types of sliding backs
The Phase One sliding back has ball bearings vs the Kapture Group sliding
back slides by friction.
! ! ! ! Kapture Group Sliding Back
! ! ! Phase One Sliding back
6
Leaf Aptus II 8
Users Guide
It is important to make sure that the Phase One sliding back is sliding to the center of travel. You must make sure that the blue disk on the right side of the back is rotated so the WHITE dot is visible. This enables the back to slide and stop in the center of travel designated by a stacked red and white dot.
! ! ! ! Center of travel
! ! ! ! Blue Disk showing white dot
7
Leaf Aptus II 8
Users Guide
Attaching the back to the computer and connecting to Capture One
I am attaching screen shots illustrating some screen shots may receive when connecting to Capture One.
You can start with Capture One already running and then attach the back or vice versa it seems not to matter. When you initially plug the cable in you should see an orange light on the top left of the back. You may then see the following dialog box.
Click OK and this preference dialog box to the right will automatically open. If you are using a view camera select Large Format, if using a Hasselblad select Hasselblad 500 Series.
This dialog box will appear automatically at the top of your screen. After this is complete the camera will connect to Capture One and the screen below will appear.
8
Leaf Aptus II 8
Users Guide
You will see this info. in the Camera tab when the back is connecting. It is important to not do anything to the back or touch Capture One while this message is visible, Leaf uploads firmware every time the back is plugged in.
If nothing happens in Capture One when you attach the back check in Capture One preferences in the Capture tab and make sure “Leaf’ is checked in the Provider section.
9
Loading...