Steps to configure
Linksys - PAP2 Analog Telephone Adaptor
Configuration Guide
Overview
This guide shows how to configure Linksys PAP2 Analog Telephone Adaptor
(ATA) so you can use the Owtalk service. But first you must be an Owtalk
subscriber.
Linksys ATA can be available in preconfigured mode, labeled as Owtalk
Preconfigured on the surface of the packaging box. Under the preconfigured
mode, all Owtalk SIP account information are pre-programmed, you don’t
need to go through the following procedures. Please refer to Appendix A on
how to activate an Owtalk preconfigured device.
Steps to self-configure
Linksys ATA
Sign up for Owtalk at http://www.owtalk.com to get your self-
1
configuration information for Linksys ATA.
Plug the power cord and connect the WAN port on the back of the ATA
2
to your cable/ADSL modem, router, or broadband Internet connection.
The factory default network setting of most of the ATA is set as DHCP
3
mode, i.e. the device obtains the IP address automatically from the network. Follow the steps below if your ATA is in DHCP mode. Otherwise
please refer to the device user manual on how to configure your device
to connect to a LAN or Internet under Static IP or PPPoE mode.
To obtain the IP address of the Analog Telephone Adaptor PAP2, press
4
110# on your traditional landline phone after connected to the adaptor
to get your IP address.
Open Internet Explorer (or any other) web browser on your computer.
5
Enter the IP address of the ATA in the address field. For example, if it is
192.168.0.109, please type http://192.168.0.109 in the address field.
A login screen will appear. Leave the User Name Field blank. Enter
6
admin
in the Password field. Then click OK button.
7
Click
Line 1
to enter the SIP Configuration. The configuration information is available in the self-configuration tab in Owtalk after sign-up or
click
View SIP Account Configuration
Fill in the 10-digits Owtalk SIP User Name in the field of Display Name, User ID and
Auth ID.
Fill in the Owtalk SIP Password in the field of Password.
Fill in the Owtalk SIP Proxy/Server in the field of Proxy.
in Owtalk
My Account
page.
The SIP port number is set at
8
default settings, or you change them to suit your setup.
Click
9
Save Settings
to enable the settings.
6060
. For the remaining tabs, you can accept the
10
After the ATA set up procedure is complete, the device is ready for use and you
can now receive and make outgoing calls.
Appendix A
Owtalk Preconfigured
Linksys ATA
To activate your Owtalk preconfigured device, you need to obtain an
activation number. Go to My Account after sign-up for Owtalk at
http://www.owtalk.com
the activation number.
Simply dial the activation number after connecting your ATA to your
cable/ADSL modem, router, or broadband Internet connection. Your ATA is
then all set and ready for use.
. Press Port to Preconfigured and click Next to get
Loading...