Line 6 Flextone Cab 112 User Manual

USER GUIDE

Thanks for buying the Flextone Cab. This satellite speaker cabinet is designed for
use with the Flextone Plus Digital Guitar Amplifier System from Line 6. Your new
Flextone Cab houses a custom-designed 12-inch Eminence speaker rated at 8 ohms
and 50 Watts max power handling capacity. To use the Flextone Cab, you simply
power down your Flextone Plus, and then connect one end of the included speaker
cable to the External Speaker output on the Flextone Plus back panel. Connect the
other end of the speaker cable to the jack on the back of your new Flextone Cab.
Then power up the Flextone Plus, and you're ready to rock the world with your
100 Watt stereo amplification and effects rig. Take a peek at the other side of this
User Guide for pictures.

The Flextone Cab is designed for stacked or side-by-side configurations with your
Flextone Plus. Put your Flextone Plus on top of the Flextone Cab for a tall setup
with a small footprint on stage or in your practice room or studio. Or spread the
Flextone Plus and Cab apart for wide stereo imaging. For ultra-wide stereo, you
can use a longer speaker cable to connect the Plus and Cab. Be sure to use a high
quality, unshielded cable, wired straight-thru, tip-to-tip and sleeve-to-sleeve.

If you run into any problems, flip to the section on technical support in the back
of your Flextone Manual, and you'll find the information you need to contact us.

That's about it. Have fun!

www.line6.com

REAR OF FLEXTONE PLUSREAR OF FLEXTONE CAB

SPEAKER OUTS

CONNECT

INCLUDED

CABLE HERE

OR

EXTERNAL INTERNAL

COMPACT STACK