Installation Instructions
Catalog Number(s) Country of Origin: Made in China •
AU7002 LyriQ Digital Audio Input Module
Doc. #1507207 05/14 Rev C
The AU7002 streams digital media content,
acting as a source input for the lyriQ
distributed audio system.
Using a smart device (Apple iPhone/iPad or Android), download and run the app “NuVo Player”. The
first screen should appear as shown to the right.
Press the top selection “Set up my new system” to begin.
NOTE: Bottom selection does not function and should not be selected.
In the enclosure, run a Cat 5 jumper cable from the “Distribution
Module Source (Single)” jack of the AU7002 to the single source
input jack of the lyriQ distribution module (AU1002 shown). Also run
a Cat 5 jumper/cable from the “LAN” jack to a switch/router device.
INSTALLATION INSTRUCTIONS
Please read these instructions completely
before you begin.
This device is verified to comply with Part 15 Class B of the FCC Rules.
860.233.6251
1.877.BY.LEGRAND
www.legrand.us
www.legrand.ca
© Copyright 2014 Legrand All Rights Reserved.
If the middle selection “Control my system” was pressed by mistake (before AU7002 has been bound
to system) the screen at the right will be displayed.
Simply press “Reset Controller” selection, or wait for the screen to time out.
NOTE: Do not click on link shown on this screen.
Assuming the top selection “Set up my new system” was selected in
step 2a above, the first screen to the right will be shown. Press the “I
do not have a NuVo Gateway” selection at the bottom of the page.
When the screen to far right is shown, press the “I understand,
continue” selection at the bottom of the page.
Since you haven’t yet bound the AU7002 to the system, it doesn’t see
any zones. Just press the “Next” selection to move to the next screen.
At this point the AU7002 should have been installed and power
applied, so its LED should be lit green. Just press the “Next’ selection
once again.
NOTE: Ignore the product picture.
Doc. #1507207 05/14 Rev C