Installation Instructions
AU7001 Digital Audio Input Module
Doc. #1507203 08/14 Rev A
INSTALLATION INSTRUCTIONS
PHYSICAL INSTALLATION
This device is verified to comply with Part 15 Class B of the FCC Rules.
The Digital Audio Input Module (AU7001) provides access to streaming music services and music files s tored
on computes and storage devices connected to the homes network.
Digital Audio system. The AU7001 takes is powered by the AU7000 Dig ital Audio Distr ibution Module. The
AU7001
this app and
Physical Installation: Install the AU7001 in the OnQ Enclosure. Connect a Cat 5
jumper from the “DIST MODULE SOURCEs (1-4) jack to one of the Source inputs of
the AU7000 Digital Audio Distribution Module. If jumpers are custom made
terminate Cat5 wires via TIA/EIA 568A. Conne
the LAN Jack.
Ensure that Keypads and sources located through the home are properly terminated
and correctly connected. Connect the a 12VCD power su
to the AU7000 and apply power.
Country of Origin: Made in China •
is setup by the Legrand D igital Audio app, availa ble for iOS a nd Android devices, and controlled by
through the Digital Audio Amplified Keypads.
Please read these instructions completely
before you begin.
Up to four (4) AU7001’s can be used in a
Ensure that all cables are connected to their respective locations.
ct Ethernet from the home network to
pply such as the PW7760
860.233.6251
1.877.BY.LEGRAND
www.legrand.us
www.legrand.ca
© Copyright 2014 Legrand All Rights Reserved.
If you haven’t already, download the Legrand Digital Audio app from the iTunes
Once the system powers up and the app makes a connection, an un-
Next, press the bind button on the AU7001. The AU7000 Digital Audio
Doc. #1507203 08/14 Rev A
or Google Play store. Ensure that the smart device you are using is connected to
the same network as the AU7000. Start the application and follow the on-screen
instructions for setup. Check all connections and power up the Digital Audio
System
configured AU7001 will be recognized and will appear as an Unconfigured Source Device. Select Settings (snap shot 1) then select
“Bind Digital Source (snap shot 2)
Distribution Module will search for the AU7001 DIM. Once it is found,
the source will be bound to the system (snap shot 2). Select “Done” to
move to the next step.