LaCie 1038 User Manual

Register your product online
for free technical support:
www.lacie.com/register.htm
go directly to manual

Table of Contents

LaCie Combo CD-RW Drive
page 1
User’s Manual
Table of Contents
Foreword 2 Precautions 4
1. Unpacking Your LaCie Drive 6
1.1. Minimum System Requirements 6
1.1.2. System Requirements 6
1.1.3 Additional Requirements for DVD-Playback and Pre-Mastering 6
2. Getting Connected 7
2.1 Install the Recording Software 8
2.2 Connect the Power Supply and Switch On the Drive 8
2.3 Connect the USB 2.0 Cable to the Drive and to Your Computer 10
3. Using Your LaCie Drive 11
3.1. Supported CD Formats 11
3.1.1. DVD-Video Zone 12
3.2. Inserting Discs 13
3.3. Ejecting Discs 13
3.4. Emergency Ejection of Discs 14
3.5. Accessing Discs 14
3.6. Writing Discs 15
4. Helpful Information 16
4.1. Advice for Optimizing USB 2.0 Connections 16
4.1.1. What Is USB 2.0? 16
4.1.2. Disconnecting USB Devices 17
4.1.3. Data Transfers 18
4.2 User Advice on MPEG-II Decoders 19
4.3 File System Formats - Definitions 19
5. Troubleshooting 20
6. Contacting Customer Support 25
7. Warranty 27

Foreword

LaCie Slim Combo CD-RW Drive
page 2
User’s Manual
Copyrights
Copyright © 2003 LaCie. All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written consent of LaCie.
Trademarks
Apple, Mac and Macintosh are registered trademarks of Apple Computer, Inc. Microsoft, Windows, Windows 98 SE, Windows Millennium Edition, Windows 2000 and Windows XP are registered trademarks of Microsoft Corporation. All trademarks mentioned in this manual are the property of their respective owners.
Changes
The material in this document is for information only and is subject to change without notice. While reasonable efforts have been made in the preparation of this document to assure its accuracy, LaCie assumes no liability resulting from errors or omissions in this document, or from the use of the information contained herein. LaCie reserves the right to make changes or revisions in the product design or the product manual without reservation and without obligation to notify any person of such revisions and changes.
Federal Communications Commission Radio Frequency Interference Statement (FCC)
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to correct the interference by one of the following measures:
• Reorient or relocate the receiving antennas.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the reseller or an experienced radio/TV technician for help.
LaCie Slim Optical Drive USB 2.0
sU2
Tested To Comply With FCC standards
FOR HOME OR OFFICE USE
Shielded cables and I/O cards must be used for this equipment to comply with the relevant FCC regulations. This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Foreword
LaCie Slim Combo CD-RW Drive
page 3
User’s Manual
Canada Compliance Statement
This Class A digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Manufacturer’s Declaration for CE Certification
We hereby certify that this device is in compliance with both the EMC Directive (89/336/EEC) and the Low Voltage Directive (73/23/EEC) issued by the Commission of the European Community.
Compliance with these directives implies conformity to the following European Norms: Class B EN60950, EN55022, EN50082-1, EN61000-3-2 With reference to the following conditions: 73/23/EEC Low Voltage Directive 89/336/EEC EMC Directive
Laser Products
This equipment is certified to comply with DHHS Rule 21 CFR Chapter I, subchapter J in effect as of date of manufacture. This equipment is classified as a Class I Laser product and no hazardous laser radiation is emitted outside the drive.

Precautions

LaCie Slim Combo CD-RW Drive
page 4
User’s Manual
Health, Safety and General Use Precautions
The drive you have just purchased includes a laser diode device, which classifies it as a "Laser Class I" product. This laser is not dangerous for the user under normal operating conditions. However, we strongly advise you not to place any reflective objects in the disc loading system, due to the risk of exposure to laser emissions that may be reflected by such objects.
Always follow the basic precautions listed below to use your LaCie drive safely and correctly. Respecting these guidelines will help to avoid the possibility of personal injury to yourself or others, as well as to prevent damage to your device and other computer equipment. These precautions include, but are not limited to, the following:
Health and Safety Precautions:
• Read this User's Manual carefully, and follow the correct procedure when setting up the device.
• Do not look inside or place your hand over the open DVD/CD media tray. Never look directly or indirectly (with a mirror) at the laser diode, even when the device is not in operation. If you expose your eyes or skin to the laser inside you drive, you risk damage or loss of your vision or other personal injury.
• Do not open your drive or attempt to disassemble or modify it. Never insert any metallic object into the drive to avoid any risk of electrical shock, fire, short-circuiting or dangerous emissions. Your drive contains no user-serviceable parts. If it appears to be malfunctioning, have it inspected by qualified LaCie service staff.
• Never expose your device to rain or use it near water or in damp or wet conditions. Never place containers on it containing liquids that may spill into its openings. Doing so increases the risk of electrical shock, short-circuiting, fire or personal injury.
• Make sure that the computer and drive are electrically grounded. If the devices are not grounded, there is an increased risk of electrical shock.
• Do not listen to audio with headphones at an excessive volume for prolonged periods of time. Doing so increases the risk of hearing damage or loss.
• Before listening to music with your drive, set the volume control to minimum. Sudden bursts of sound at loud volumes can cause immediate hearing damage or loss.
Precautions
LaCie Slim Combo CD-RW Drive
page 5
User’s Manual
General Use Precautions:
• Do not expose the drive to temperatures outside the range of 5° C to 45° C (41° F to 104° F). Doing so may damage the drive or disfigure its casing. Avoid placing your drive near a source of heat or exposing it to sunlight (even through a window). Inversely, placing your drive in an environment that is too cold or humid may damage the unit.
• Always unplug the drive if there is a risk of lightning or if it will not be used for an extended period of time. Otherwise, there is an increased risk of electrical shock, short-circuiting or fire.
• Do not place heavy objects on top of the drive or use excessive force on its buttons, connectors and tray. Doing so increases the risk of damage to the device.
• Always place your drive in a horizontal position before using it. Otherwise, it may fall, causing damage to the device and / or corruption or loss of data.
• Always remove the disc from the disc tray before transporting your drive. Otherwise, written data may be destroyed or the drive's internal components may be damaged.
• Never use excessive force on the disc loading system; discs should be inserted effortlessly into your drive. If you detect a problem, consult the T
• Protect your drive from excessive exposure to dust during use or storage. Dust can build up inside the device, increasing the risk of damage or malfunction.
• Never use benzene, paint thinners, detergent or other chemical products to clean the outside of the drive. Such products will disfigure and discolor the front panel and casing. Instead, use a soft, dry cloth to wipe the device.
roubleshooting section.

Unpacking Your LaCie Drive

LaCie Slim Combo CD-RW Drive
page 6
User’s Manual
1. Unpacking Your LaCie CD-RW Drive:
You’ll tear through your work with your new LaCie Combo CD-RW Drive. Boasting over 485 times the capacity of floppy disks, CD media is the perfect tool for sharing information between different systems. You can create discs full of word documents, spreadsheets, music, pictures and video, and pass them along to any other computer with a CD-ROM drive. And the drive also has the capability of reading DVD-ROM and DVD-Video discs.
3
1
6
4 5
2
1) LaCie Combo CD-RW Drive
2) External Power supply
3) Hi-speed USB 2.0 mini certified cable
4) LaCie CD Utilities CD-ROM
5) Blank LaCie CD-R media (1)
6) USB Power sharing cable
1.1. Minimum System Requirements
1.1.1. Hardware Requirements:
•PC or Mac with USB 2.0 or 1.1 interface*.
•Intel Pentium 233MHz compatible processor or greater; 32MB RAM minimum
•Minimum 100MB hard disk space for installing LaCie CD Utilities
•Minimum 800MB hard disk space for copying a CD onto the hard disk
Tech Note: *In order to play-back DVD-Video discs with your USB 2.0 LaCie Drive, your computer must be installed
with a USB 2.0 host bus adapter card. USB 1.1 does not offer the capacity required for DVD-Video playback. If your computer is not equipped with a USB 2.0 host bus adapter card, either natively or through a third party reseller, LaCie offers USB 2.0 PCI cards. Please contact your LaCie reseller or LaCie Customer Support for more details. See section 4.1 Advice for Optimizing USB 2.0 Connections
for more info.
1.1.2. System Requirements:
•Mac OS 9.1 and 10.1.2 or later
•Windows 98 SE (Second Edition), Windows Me (Millennium Edition), Windows 2000, or Windows XP
1.1.3. Additional Requirements for DVD Playback and Pre-mastering:
• Video Card supporting DirectDraw Standard
• Audio Card supporting 44.1KHz or 48KHz sampling rate
• Monitor Resolution of 1024 x 768, 24-bit color
• Microsoft DirectShow 6.4 or greater
Getting Connected
LaCie Slim Combo CD-RW Drive
page 7
User’s Manual

2. Getting Connected

Follow these steps to quickly get your LaCie Drive powered on and connected to your computer. Click on a step to get started!
2.1. Install the Recor
2.2. Connect the Power Supply and Switch On the Drive
2.3. Connect the USB 2.0 Cable to Your LaCie Drive and to Your Computer
Once you’ve gotten the drive powered on and connected to your computer, move on to section 3. Using
Your LaCie Drive for important information on how to utilize your drive.
ding Software
Getting Connected
LaCie Slim Combo CD-RW Drive
page 8
User’s Manual
Step 2.1. –
From you LaCie CD Utilities CD-ROM, open the software folders, click on the install icons (Windows Users: click on the Setup.exe icon; Mac Users: double-click the Installer icon) of the various programs and follow the on-screen instructions to install the programs. For more information about the various programs, please refer to the Help sections of the specific software program.
Windows Users
LaCieCDUtils (D:)
Windows 98 SE and Windows Me Users!
Before continuing, first install this important software to help you configure and manage your LaCie drive.
From the LaCie DVD Utilities CD-ROM:
A) Double-click the USB 2.0 Drivers folder.
B) Double-click on the LaCie_USB_Driver_Install.exe icon. The LaCie USB2 Storage Driver screen will appear. Click on Next.
C) Installation will finish automatically.
Step 2.2 –
Connect the power supply and switch on the drive.
Your LaCie Drive includes two types of external power supplies: an external power supply (Option A) and a USB Power Sharing Cable (Option B). Use Option A when you are using your drive near an electrical outlet, and use Option B when you do not have access to an electrical outlet and wish to draw power from your computer.
Loading...
+ 19 hidden pages