Kyocera FS-6970 Service Bulletin 5H2 0001 B386

the left side )

.

FIG1

FIG2

Service Bulletin Ref. No.

Subject

5H2-0001 (B386)

[Service information]

Measures against the Paper Jam on the Optional Paper
Feeder

<Date> October 28, 2011

(Page.1/1)

Model

(Installation target modes of PF-430: FS-6950DN and FS-6970DN)

PF-430

Topic

No-feed jam or accordion jam might occur due to a loose connector.
If a paper jam occurs, please check the motor connector and securely insert it if it is loose.

<How to remove the top cover>
When removing the top cover, two
springs will be found at the both left and
right sides. Remove the top cover upright
while taking care not to lose them.

1) Pull out the cassette.

2) Unscrew four of the screws on the top
cover (marked with bold arrows in
FIG1).

3) Unlatch the both hooks inside (one

each on the right and left sides) where
the cassette was seated (FIG2).

4) Remove the top cover.

<Checkpoint of the connector>

NG

If the connector is loose or
disconnected, a jam may occur

KMC’s Classification Entire Stock Rework In-Field modification at next visit

Field Measure: Please check the motor connector if a paper jam occurs on the optional paper feeder.

Loose

PF-430

In-Field modification by case No modification necessary

Top cover

OK

Removed cassette (right side)

Push the hook
to unlatch

Correct connection

(same for

European Service & Development Center (ESDC)

KYOCERA MITA Europe B.V.