Kyocera FS-1120, FS-1030MFP, FS-1028, FS-1320, FS-1370 Service Bulletin COM 0200 A324 1
...
the
Subject
(Revised issue 1)
Service Bulletin Ref. No.
[Service Information]
<Date> January 12 2012
COM-0200 (A324)
Note When Replacing/Reassembling the HOLDER DU and
STAY DU
(Page.1/2)
FS-1300D, FS-1350DN, FS-1120D, FS-1320D, FS-1370DN,
Model
FS-1028MFP, FS-1128MFP
(-->) FS-1030MFP, FS-1130MFP, FS-1035MFP, FS-1135MFP
This time, the description with (-->) was revised from the previous information.
<Number of changes: 4> The affected models were added.
Topic
The HOLDER DU (No.2) and the STAY DU (No.3) are no more supplied as individual parts since adjustment is
required after assembling.
If the HOLDER DU/STAY DU must be replaced, please use the assembly part (No.1) instead of the parts above.
Precaution
In case of replacing/reassembling the HOLDER DU/STAY DU individually, the paper skew may occur depending on
the adjustment.
European Service & Development Center (ESDC)
PULLEY MID(Y)
HOLDER DU ASSY (No.1)
KYOCERA MITA Europe B.V.
STAY DU (No.3) -->
No more supplied.
SHAFT PULLEY (X)
HOLDER DU (No.2)
--> No more supplied.
Q’
Com
bi
p
ati-
(Revised issue 1)
Service Bulletin Ref. No.
[Service Information]
<Date> January 12 2012
(Page.2/2)
COM-0200 (A324)
No.
The part with “O” in the SP column is a regular maintenance part. "+" Mark at the head of the description indicates that it is a
component part.
*1: Assembly part containing one piece of HOLDER DU (No.2), STAY DU (No3) and SHAFT PULLEY (X on the figure above:
302FM0242_) and two pieces of PULLEY MID(Y: 2FM0221_)
Old Part
No.
1 ------------
2FM21010
2
5MVX861XB001
2FM21020
3
5MML821SD009
New Part
No.
302FM94060
2FM94060
------------ +HOLDER DU - -
------------ +STAY DU - -
Description
PARTS HOLDER DU
ASSY SP
ty
Old New Old New
- 1
lity
- O O
- - -
- - -
SP
*1
Supply as individual
part is discontinued.
Supply as individual
part is discontinued.
Remarks
KMC’s Classification Entire Stock Rework In-Field modification at next visit
In-Field modification by case No modification necessary
Field Measure:
Please use the assembly parts (No.1) if HOLDER DU (No.2) and STAY DU (No.3) must be replaced.
And, please don't remove HOLDER DU and STAY DU individually.
(Please don't reassemble them in the field.)
Serial Nos. of Affected Machine: ---------------------------------------
European Service & Development Center (ESDC)
KYOCERA MITA Europe B.V.
Loading...