Kyocera FS-1120, FS-1320, FS-1370 Service Bulletin 2L0-001

Service Bulletin

SB Number:

Subject:

SB 2L0-001

Failure to use the USB memory properly

Model: FS-1370DN

Item Contents

1 Failure to recognize

USB memory due to
the static electricity.

2 Failure to recognize

USB memory while
power is supplied to

the machine.

Phenomenon

The USB memory may not to be recognized or the stored les can not be printed, due to

the static electricity.

Details

1. The “>” mark does not appear, after selecting the “USB Memory” with the Menu key.

2. The “>” mark does appear, the le can not be selected when moving with “>” and
when pressing “OK’ twice at “Print le”.

3. The arrow mark does appear and the le can be selected, the le can not be printed,
while “Processing” is displayed followed by the “Ready” message.

Solution

1. Please turn the machine OFF and ON.

2. Remove the USB memory from the USB host, and reconnect it.

3. Remove the USB memory from the USB host, and reconnect it.

Phenomenon

The USB memory may not be recognized and the message “the USB memory is

disconnected” may be displayed.

Cause

When the USB memory is connected to the USB host, the 5V power is supplied to the
USB memory. After the machine recognizes the USB memory, it waits for a certain amount
of time before receiving the signal to connect the USB memory. If the signal is not received
in time, the USB memory can not be recognized.

Creation Date: 25/08/2010

KMIS Service Department, Kyocera Mita Europe A157 / SB 2L0-001

Page 1 of 1