Knight Equipment KMP-DD Installation Manual

KMP-DD (7865453) OPERATION & PROGRAMMING GUIDE

Four digit LED display

Select button

Enter button

Power switch OFF/ON

Single pump with 2 2-lead

signal input cables

24 -240 VAC input

Front View

Summary Table

Bottom View

P____

Password to Access the programming menu Setting from factory is
set to 000

V Charge speed (10 – 100%)

1

Set pump speed to run when the CHARGE signal is activated

V Rinse speed (10 – 100%)

2

Set pump speed to run when the Rinse signal is activated

T Charge time (0 – 999 sec)

Set Charge time. A 000 setting pump will run as long as the Charge

3

signal is active

T Rinse time (0 – 999 sec)

Set Recharge time. A 000 setting pump will run as long as the Rinse

4

signal is active

T Wait time (0 – 999 sec)

Delay time for the Charge time. When a time is programmed, any
signal will activate the recharge then the Wait will elapse then the

5

Charge time will activate. A 000 setting will operate Charge and Re­charge independently.

Speed enable/disable in On line mode (ON – OFF)

On means that while the signal is active and the pump running you

6

will be able to change the speed of the pump while it’s running

Rev: REL (11/11) Page 1

0

Hid

ESC

Password setting

Exit menu saving settings

Exit menu without saving settings

KMP-DD (7865453) OPERATION & PROGRAMMING GUIDE

OPERATION

1. Connect signal input 100 to 240VAC

2. CHARGE signal to RED and WHITE wires

3. RINSE signal to BLACK and BLUE wires

4. Turn main power switch to OFF (0)

5. Turn CHARGE signal ON to 100-240VAC

PROGRAMMING

6. Display will show Sby

8. Factory Passcode is 000. Press TIME/
ENTER button four times until display
shows MENU 1 100 (none flashing)

10. While 1 is flashing change number by
pressing Dosing button.

7. Press and hold TIME/ENTER button for
5 seconds display will show P——
(Password Screen)

9. To change setting press the TIME/
ENTER button once, the 1 will flash.

11. While 1 is flashing change number by
pressing Dosing button.

12. Hit TIME/ENTER button to enter
value and move to the next number. Re-

13. Press the DOSING button once to

change to MENU 2 100
peat steps 10 through 12 to change the rest
of the digits

14. Repeat steps 9 through 13 to change
menu 1 through 6

Page 2 Rev: REL (11/11)