Knight Equipment KMP-AD Installation Manual

KMP-AD (7865451) / KMP-AR (7865452) OPERATION GUIDE

LED indicator

Potentiometer

3 way power switch

OFF/ON/MOM

Single pump with 2 lead

signal input cable

24 -240 VAC input

Front View

OPERATION

Bottom View

1. Connect signal input 24 to 240VAC

2. Prime pump by pressing and holding switch to
MOM position until pump is primed

3. Turn main switch to ON

4. Pump will run and LED flash GREEN

5. Turn the potentiometer clockwise to increase speed
of the pump

6. For pump to operate, leave switch to ON position

7. When signal activates pump will run at the set
speed for however long the signal is present and the
LED will flash intermittently GREEN

Note: If signal is on and the main switch in the OFF posi­tion the LED will FLASH intermittently RED

Rev: REL (11/11) Page 1