Knight Equipment KLE-175GT Installation Manual
./(*7',63(16(5
,167$//$7,210$18$/
INTRODUCTION
Low-energy dishwashing machines have long been recognized as a platform for dispensing chemicals. For the lowenergy dishmachine service distributor revenues are predicated on the success or failure of the dishmachine’s ability
to dispense detergent, sanitizer and drying agent.
Knight’s leadership position in chemical dispensing technology and our keen interest in developing chemical revenue
opportunities for our customers helped inspire this exciting new chemical dispensing package.
THEORY OF OPERATION
The “GT” dispenser mounting bracket is designed to fit under the dishmachine pan and on top of the stand just in
front of the pump motor. A variety of dispensers designed to dispense pot and pan detergent or grease trap chemical
treatment can be mounted together or as separate systems on this bracket.
Electrical power (110 VAC) is supplied by a dispenser power terminal strip located in the dishmachine control box.
9641615 Rev: REL (10/01) Page 1 of 4
MOUNTING
(1) Mount “L” bracket to front two holes on dishmachine
stand using supplied 1/4-20 bolts as shown. Connect
the top of the mounting bracket to the pan bracket.
(2) Cut 3-lead power cord to proper length (8 feet) and
wire to primary at dispenser transformer (110 VAC)
terminal strip.
(3) Route 3-lead power cord through dispenser strain
relief and push through strain relief on mounting
bracket.
Page 2 of 4 9641615 Rev: REL (10/01)
Loading...