JVC DR-MV7S Faqs

JVC Customer Care Center

1-800-252-5722

DR-MV7S Quick Guide FAQ’s

Thank you for your purchase of the JVC DR-MV7S VHS/DVD Player/Recorder.
If you have any questions regarding the hookup or operation of your DR-MV7S, please contact our

Customer Care Center at 1-800-252-5722.

Please Note:

Be sure to connect the AC power plug into the power outlet after all other connections are completed.

What DVDs can I use to record on my
DR-MV7S?

cc

DVD-R, DVD+R, DVD-RW and DVD+RW can be
used to record on your DR-MV7S.
DVD-RAM will not be recognized as record­able media on your DR-MV7S.

The Clock on my DR-MV7S is not setting
automatically. I am not using a cable box.
Is this a malfunction?

The default setting is Auto Clock: OFF.

cc

Change the setting to ON (Auto) by following
the instructions on page 20 of your owner’s
manual.

The clock on your DR-MV7S may not set automati­cally in some geographical areas.

cc

If the clock does not set automatically even
when the Auto Clock is set ON (Auto), you
may set the clock manually by following the
instructions on page 21 of your owner’s man­ual.

Remote control unit does not work.
Timer Recording does not work.

When the power to your DR-MV7S is interrupted
by power outage or by disconnecting AC Plug;

• The remote control code of the main unit
defaults to “C” code.

• The date and time information will be lost. If
the Auto Clock setting is ON (Auto), the
clock time will be automatically updated
when broadcast signal is available.

• If you have programmed timer recording,
that data will be lost and needs to be repro­grammed.

cc

Perform the setting again by referring to
each relevant page of owners manual.
Remote control code setting: page 24
Clock setting: page 20
Timer recording setting: page 37

For additional troubleshooting tips please refer to pages 51-53 in your owners manual.

3840R-L005U

When I turn on my DR-MV7S it flashes
“Hello” and all the buttons on the remote
control and the front panel will not respond
for 10 - 15 seconds. Is this normal?

When your DR-MV7S is first turned on, it will flash
“Hello” as the internal EPROM chip is updated with
information.

c Please wait until “Hello” stops flashing before you

attempt to use the remote control or front panel
buttons. It takes 25-30 seconds until the set

can be operated when a disk is on the tray.

My DR-MV7S is showing a distorted picture.

Your DR-MV7S has a progressive scan feature.
This feature only works with a TV that accepts a pro­gressive scan signal.

cc

If the picture is distorted, press OUTPUT STA­TUS button and select 480i.

My DR-MV7S is showing no picture.

There is no signal output other than HDMI when
HDMI is connected and 720p/1080i is selected at
OUTPUT STATUS.

cc

Press OUTPUT STATUS button and select
either 480i or 480p in order to watch the video
signal from AV OUT, S-VIDEO OUT, COMPO­NENT/PROGRESSIVE SCAN VIDEO OUT.

My newly recorded DVD plays in my
DR-MV7S but does not play in other DVD
players.

c You must “Finalize” the DVD before it can play in

another DVD player.
Please see page 23 in your owner’s manual.

LPT1133-003A

0606MNH-LG-LG