John Deere W660, T660, T550, W650, W550 User Manual

...
John Deere W&T-Series Combines Cleaning Guide
(W540, W550, W650, W660, T550, T560, T660, T670)
IMPORTANT: Regular and thorough cleaning of machine combined with other routine maintenance procedures listed in the Operator’s Manual greatly reduce the risk of
re, chance of costly downtime, and improve
machine performance. Crop material and other debris can
accumulate in various areas. Direction of wind, type of crop, and crop moisture
content can all impact where and how much crop material and debris can accumulate.
Be aware of harvest conditions and adjust
your cleaning schedule to ensure proper
3
machine function and to reduce the risk of
re. These areas may require more frequent cleaning, even multiple times per day, depending on harvest conditions.
Inspect and clean these areas as needed
throughout the harvest day. Other areas not covered in this section may
also collect crop debris and MUST be cleaned
periodically for machine function and appearance.
Thoroughly inspect the entire machine on a regular basis throughout the harvest season.
Refer to the Machine Cleanout Section of your Operator’s Manual for further information.
2
1
3A
Engine Platform
Area of rear access platform and cooling
package (1).
Area on top of engine, around turbo
charger, and alternator(s) (2).
Area around hydraulic oil reservoir and
exhaust (3).
Area around and inside Exhaust
Aftertreatment Enclosure (3A).
Wiring Harnesses and Hydraulic Hoses
Right Cab Area (4).
3-Speed Transmission or ProDrive Transmission (5).
4
5
READ SAFETY INFORMATION IN OPERATOR’S MANUAL
Always follow all safety procedures posted on the machine and in the Operator’s Manual. Before carrying out any
inspection or cleaning, always shut OFF engine, set parking brake, and remove key.
IMPORTANT: Thoroughly clean the
machine from top to bottom with
compressed air. First clean all areas
accessible from engine deck. Start with cleaning cooling package. Restart engine after cleaning cooling
package area. Run engine briey at high
idle to clear dislodged crop debris from
cooling package area. Shut OFF engine and remove key. Continue cleaning in
engine compartment. Blow crop debris out towards left side of machine.
Work outwards and counterclockwise to
other areas around engine compartment
and rear deck. Thoroughly clean around
turbocharger and exhaust manifold areas
on engine. Thoroughly clean outside area
around Exhaust Aftertreatment Enclosure
(if equipped.) Open top access door
on Exhaust Aftertreatment Enclosure.
Thoroughly clean inside of enclosure, around the sensor locations, band clamps,
and outer surfaces of canister. Once top
rear areas around engine compartment, Exhaust Aftertreatment Enclosure, and
rear deck are clean proceed to clean remaining areas accessible from ground
level.
6 7
Shields and Braces
Left side of feeder house, on reverser
gearcase (6).
Left side of frame, behind tailings
elevator (7).
Wiring Harnesses and Hydraulic Hoses
Area behind Battery Box (8).
Rear Hood Area
Below rear straw walker shaft (9).
8 9
Copyright © 2014 Deere & Company. All Rights Reserved. THIS MATERIAL IS THE PROPERTY OF DEERE & COMPANY. ALL USE AND OR REPRODUCTION NOT SPECIFICALLY AUTHORIZED BY DEERE & COMPANY IS PROHIBITED.
All information, illustrations, and specifications in this manual are based on the latest information available at the time of publication. The right is reserved to make changes at any time without notice.
HXE62633 (08SEP14)
Loading...