Intel Learning Series Quick Start Manual

2 Connections

1 Congratulations!

Congratulations on your purchase of an

Left

1. Headphone jack

2. Microphone jack

3. USB 2.0 port #1

1 2 3

Right

4. USB 2.0 port #2

5. SD Card Reader

6. Ethernet Port

7. Power Input

4 5 6 7

Intel-powered clamshell classmate PC.
Follow these simple instructions to get
your classmate PC up and running.

What’s in the box

Intel-powered clamshell classmate PC
Power adapter

Replace Battery

1. Unlock static latch

2. Hold spring latch and
lift battery out

3. Snap replacement battery
into slot

4. Lock static latch

Intel-powered
clamshell classmate PC

Hardware Quick Start Guide

Part of the Intel® Learning Series

© 2008, Intel Corporation. All rights reserved. Intel, and the Intel logo

are trademarks of Intel Corporation in the U.S. and other countries.

* Other marks and brands may be claimed as the property of others.

1208/MG/CMD/PDF 318938-002 US

3 Charge Battery 4 System/Power Status Indicators 5 Start The Computer 6 Set Up A Connection

1. Connect the AC Power Cord to the Power Adapter.

2. Connect the Power Adapter to the computer Power Input.

3. Plug the Power Cable into a Wall Outlet.

IMPORTANT:
The battery must be charged for at least six hours before

rst use. The battery charge indicator will become green when

the battery is fully charged. Keep the power cable away from
young children.

Power

Input

Power

Cable

AC Power

Cord

Power

Adapter

The row of icons located above the keyboard light up with
different colors to indicate the system and power status of
your classmate PC.

Icon System/power indication

Green light: Wireless local area network (WLAN) module is active.

Green light: Numeric keypad is activated.

Green light: Caps lock is activated.

Green light: The battery is charged.

Orange light: The battery is being charged.

Blinking orange light: Battery power is low.

Alternating green and orange light (when the AC adapter is

plugged in): The system has stopped charging the battery because

the battery pack temperature is too high.

Green light: The system is on.

Press and hold the Power Button for three seconds or until the
screen turns on.

If the screen does not turn on, check the power connection and
strength of the battery. Refer to the user’s manual for
troubleshooting tips.

Power

Button

Set Up a Wired Connection

1. Connect an Ethernet Cable to your classmate PC.

2. Connect the other end
of the Ethernet cable to
a cable modem, DSL
modem, or network.

Ethernet Port

Set Up a Wireless Connection

1. Verify the WLAN module is active (the wireless icon
light will be green). If it is not, press the Fn key and the
F1 key simultaneously.

2. Click Start.

3. Click Control Panel.

4. Double-click the Wireless icon.

5. Follow the instructions on screen.

Status

Indicators