Page 1
Quick Setup Guide
Crosscut Paper Shredder | NS-PS10CC
Features
Power switch
Handle
Paper or disc slot
Shredder head
Wastebasket
Power switch
auto The shredder starts automatically when an item is inserted into the paper or disc slot.
When the item has passed through the slot, the shredder stops.
o Turns o the shredder.
LEDs
LEDs
Power
Lights green when the shredder is in use. Turns o when the shredder is in
standy-by (power-saving) mode.
Overheat/Overload
Lights red when the shredder is jammed or overheated, you have inserted
more sheets of paper than recommended or the shredder has been used
too long.
Door Open
Lights yellow if the wastebasket is opened or the shredder head is not
mounted correctly.
Setting up the shredder
1 Place the shredder head securely on the rim of
the supplied wastebasket.
Caution: Your shredder has very sharp, exposed
blades on the underside. Use care when mounting the
shredder to the wastebasket.
Note: Do not use bags to line the wastebasket.
2 Connect the power cord to a power outlet.
Using the shredder
Warning: Always turn o the shredder when it is not in use.
Caution: Do not insert more than 10 sheets of paper, one credit card, or one disc at a
time. You may damage the shredder.
To shred paper:
Insert paper into the paper or disc slot. When the paper has passed
through, the shredder will stop.
Caution: Always feed paper in as straight as possible to avoid paper jams.
To shred discs and credit cards:
Hold the disc or credit card by the edge and feed
into the paper or disc slot one at a time, releasing
when shredding begins. The shredder stops when
the entire disc or credit card has been destroyed.
Caution: Do not hold the disc with your nger through
the center hole while feeding it into the shredder.
Serious injury may occur. Never feed more than one disc
or credit card at a time.
Notes:
• Never shred plastic (except credit cards, CDs, or DVDs), continuous forms, anything
with adhesive including labels and envelopes, newsprint, or any hard materials.
• While this shredder will shred staples and small paperclips, it is recommended that
you remove them whenever possible to extend the life of your shredder.
rev Use the reverse setting to clear a paper jam or to pull out unshredded paper.
Caution: Never try to clear a jam by using REV when the wastebasket is full. This could make the jam
worse.
Before using your new product, please read these instructions to prevent any damage.
3 Slide the power switch from o to auto.
Page 2
Troubleshooting
PROBLEM
The shredder does not
stop running
The shredder is
jammed
The shredder will not
run
The Door Open LED
turned on
The Overheat/Overload
LED turned on
SOLUTION
• Slide the switch to o, unplug it from the power outlet, then empty the
wastebasket.
• Slide the switch to o, unplug it from the power outlet, then push the
shredded paper down to make sure that it is away from the shredder
head.
• Slide the switch to rev to remove extra paper, disc, or credit card from
the shredder.
• Slide the switch to rev to remove the stuck paper, disc, or credit card.
• Make sure that you only send 10 sheets of paper, one credit card, or one
disc through the shredder at a time.
• Change the position of the paper as you insert it.
• The paper may be too thin or crumpled for the shredder to recognize it.
Fold the paper, then reinsert it.
• Slide the switch to rev to remove any stuck paper, discs, or credit cards.
• Make sure that you only send 10 sheets of paper, one credit card, or one
disc through the shredder at a time.
• Unplug the shredder from the power outlet and let it cool for at least 50
minutes.
• Make sure that the shredder head is placed on the wastebasket correctly.
• Make sure that the shredder head is placed on the wastebasket correctly.
• Slide the switch to o, unplug the shredder from the power outlet,
then empty the wastebasket.
• Reduce the number of sheets you are shredding or stop shredding until
the LED turns o.
Specications
Sheet capacity 10 sheets of 20 lb. bond paper
Credit card capacity One at a time
Disc capacity One at a time
Paper shred size 5/32" × 1 9/20" (0.4 cm × 3.7 cm) pieces
Voltage 120V - 60 HZ 4.3A
Important safety information
• RISK OF FIRE. NEVER dispose of ammable chemicals or materials that
have come into contact with ammable chemicals (for example, nail
polish, acetone, gasoline) in the wastebasket.
• Always turn the shredder o and unplug the power cord from the AC
outlet before cleaning it, moving it, or emptying the wastebasket.
• Never place the shredder near water or any heat source.
• Never use any petroleum based or ammable oils or lubricants in or
around the machine as some oils can combust causing serious injury.
• Never spray any aerosol based products in or around shredder.
• Never shred envelopes, labels, or anything with glue or any sticky
substance as this will lead to paper jams.
• Do not use the shredder if the power cord is damaged in any way.
• Do not attempt to service this product yourself as doing so may expose
you to sharp cutting blades and electricity and will void the
manufacturer’s warranty.
• Never let the wastebasket become full. This will lead to shredded material
being pulled back up into the shredder and cause jams.
• The socket-outlet shall be installed near the equipment and shall be easily
accessible.
One-year limited warranty
Visit www.insigniaproducts.com for details.
Contact Insignia:
For customer service, call 1-877-467-4289 (U.S. and Canada) or
01-800-926-3000 (Mexico)
www.insigniaproducts.com
INSIGNIA is a registered trademark of BBY Solutions, Inc. Registered in some countries.
Distributed by Best Buy Purchasing, LLC, 7601 Penn Ave South, Richeld, MN 55423 U.S.A.
©2014 BBY Solutions, Inc. All Rights Reserved.
Maintaining
Once a month, drizzle vegetable oil or cooking oil (nothing petroleum based)
on a few pieces of paper and feed them through the shredder.
WARNING
Product is
not intended
for use by
children
(product is
not a toy)
Avoid
touching the
paper or disc
slot with
hands
Avoid loose
clothing or
jewelry
touching the
paper or disc
slot
Do not spray or
keep any aerosol
products in or
around shredder
Avoid getting
hair near the
paper or disc
slot
Do not insert
foreign objects
into the paper
or disc slot
V2 ENGLISH 14-0476
Loading...