IMG Stageline LSX-300SRGB User manual
Bestellnummer 38.6180
VERSION: V 3.0
This manual contains important laser system safety and operation
information. Read and understand all instructions prior to pow ering on
laser unit the first time, to avoid laser e ye injury and to avoid breaking
the law. Keep this manual in a safe place for future reference.
USER MANUAL
WARNING DATA
Lasers can be hazardous and have unique safety considerations.
Permanent eye injury and blindness is possible if lasers are used
incorrectly. Pay close attention to each safety REMARK and
WARNING statement in the user manual. Read all instructions
carefully BEFORE operating this device.
Attention!
Important!
Caution!
Laser!
Recycle
Indoor
Wastebin
LLocation
Indicates a skill or other useful information for special
situation.
Indicates important information, to protect people from laser
incident or damage
Prevent damage or injury from incorrect operation.
Laser safety warming labels.
To protect the environment, recycle packing material
wherever possible.
The projector is for indoor use only, IP20. Use only in dry
locations. Keep this device away from rain and moisture,
excessive heat, humidity and dust. Do not allow contact with
water or any other fluids, or metallic objects.
Don’t throw this product away just as general trash, please
dispose of this product following the abandon electronic
product regulation in your country.
The projector must be installed in a location with adequate
ventilation, at least 50cm (20inches) from adjacent surfaces.
Be sure that no ventilation slots are blocked.
1
USER MANUAL
LASER SAFETY WARNINGS
Potential laser injury hazard exists with this product! Read these
Instructions carefully, which include important information about
installation,safe use and service!
Caution
Avoid direct eye contact with laser 了 light. Never
intentionally expose your eyes or others to direct laser
radiation.
Caution
This laser product can potentially cause instant eye
injury or blindness if laser light directly strikes the eyes.
Caution
It is illegal and dangerous to shine this laser into
audience areas, where the audience or other personnel
could get direct laser beams or bright reflections into
their eyes.
Caution
It is a US Federal offense to shine any laser at aircraft.
Caution
There are no user serviceable parts inside the unit. Do
not open the housing or attempt any repairs yourself. In
the unlikely event your unit may require service, please
contact the dealer nearest to you.
Caution Use of controls or adjustments or performance of
procedures other than those specified herein ma y result
in hazardous radiation exposure.
NON-INTERLOCKED HOUSING WARNING
This unit contains high power laser devices internally. Do not open the laser
housing, due to potential exposure to unsafe levels of laser radiation. The
laser power levels accessible if the unit is opened can cause instant
blindness, skin burns and fires.
2
USER MANUAL
LASER SAFETY AND OPERATING INSTRUCTIONS
STOP AND READ ALL LASER SAFETY DATA
Laser light is different from any other light source witch you may be familiar. The
light from this product can potentially cause eyes injury if not set up and used
properly.
Laser light is thousands of times more concentrated than light from any other kind
of light source. This concentration of light power can cause instant eye injuri es,
primarily by burning the retina (the light sensitive portion at the back of the e ye).
Even if you can not feel “heat” from a laser beam, it can still potentially injure or
blind you or your audience. Even very sm all amounts of laser light are potentiall y
hazardous even at long distances. Laser eye injuries can happe n quicker than
you can blink.
It is incorrect to think that because these laser entertainment products split the
laser into hundreds of beams or laser beam is scanned out in high speed, that an
individual laser beam is safe for eye exposure. T his laser pr oduct us es d ozens of
milliwatts of laser power (Class 3B levels internally). Many of the individual beams
are potentially hazardous to the eyes.
It is also incorrect to assume that because the laser light is moving, it is safe. This
is not true. Nor, do the laser beams always move. Since eye injuries can occur
instantly, it is critical to prevent the possibility of any direct eye exposure. In the
laser safety regulation, it is not legal to aim Class 3B lasers in areas which people
can get exposed. This is true even if it is aimed below people’s faces, such as on
a dance floor.
z
Do not operate laser without first reading and understanding all safety and
technical data in this manual.
Always set up and install all laser effects so that all lasers light is at least 3
z
meters (9.8 feet) above the floor on which people can stand. See “Proper
Laser Set-up & Usage” section later in this manual.
z
After set up, and prior to public use test laser to ensure proper function. Do not
3
USER MANUAL
use if any defect is detected. Do not use if laser emits only one or two laser
beams rather than dozens/hundreds, as this could indicate damage to the
diffraction grating optic, and could allow emission of higher laser levels.
z
Do not point lasers at people or animals.
Never look into the laser aperture or laser beams.
z
Do not point lasers in areas in which people can potentially get exposed. such
z
as uncontrolled balconies, etc.
z
Do not point lasers at highly reflective surfaces such as windows, mirrors and
shiny metal. Even laser reflections can be hazardous
Never point a laser at aircraft, this is a federal offense.
z
z Never point un-terminated laser beams into the sky.
z Do not expose the output optic (aperture) to cleaning chemicals.
z
Do not use laser if the laser appears to be emitting only one or two beams.
Do not use laser if housing is damaged or open, or if optics appear damaged
z
in any way.
z Never open the laser housing. The high laser power levels inside of the
protective housing can start fires, burn skin and will cause instant eye injury.
z
Never leave this device running unattended.
The operation of a Class 3B laser show laser is only allowed if the show is
z
controlled by a skilled and well-trained operator familiar with the data included
in this manual.
z
The legal requirements for using laser entertainment products vary from
country to country.The user is responsible for the legal requirements at the
location/country of use.
z Always use appropriate lighting safety cables when hangin g lights and effects
overhead.
For the operation of the laser the “INTERLOCK CONNECTOR” must be connected.
z
FOR GERMANY: Customers have to use an ”EMERGENCY SWITCH”
together with the “INTERLOCK CONNECTOR”.
LASER EXPOSURE WARNING
LASER LIGHT
AROVID DIRECT EYE EXPOSURE
Further guidelines and safety programs for safe use of lasers can be found in the
ANSI Z136.1 Standard “For Safe Use of Lasers”, available from
“www.laserinstitute.org”. Many local governments, corporations, agencies,
military and others, require all lasers to be used under the guidelines of ANSI
Z136.1. Laser Display guidance can be obtained via the International Laser
Display Association, www.laserist.org
.
4
USER MANUAL
LASER SAFETY LABEL REPRODUCTIONS
Caution – Class 3B LASER RADIATION,
WHEN OPEN, AVOID EXPOSURE TO
BEAM
LASER RADIOATION AVOID EXPOSURE
TO BEAM CLASS 3B LASER PRODUCT.
The label indicates the laser beam output
aperture.
LASER EMISSION DATA
Laser Classification Class 3B
Beam Diameter <5mm at aperture
Divergence(each beam) <2 mrad
Divergence(total light) <40 degrees
Cooling TEC & Fan Cooling
Scanning ILDA Standard: 15Kpps
* As measured under IEC measurement conditions for classification.
Note: The laser diode is exposed to extreme conditions due to the
high output power and therefore only has a limited life. Like all
wear parts, the laser diode is not subject to any guarantee claims.
5
USER MANUAL
LASER COMPLIANCE STATEMENT
This laser product complies with EN/IEC 60825-1 Ed 2, 2007-03.
GENERAL SAFETY INSTRUCTIONS
Every person involved with installation and maintenance of this device has to
z
Be qualified.
Follow the instructions of this manual.
z
CAUTION! Be careful with your operations. With a high voltage
you can suffer a dangerous electric shock when
touching the wires!
This device has left out premises in absolutely perfect condition. In order to
maintain this condition and to ensure a safe operation, it is necessary for the user
to follow the safety instructions and warning notes written in this manual.
Important! The manufacturer will not accept liability for any resulting
damage caused by the non-observance of this manual or any
unauthorized modification to the device.
z
Please consider that damages caused by manual modifications to the d evise
are not subject to warranty.
Never let the power-cord come into contact with other cables! Handle the
z
power-cord and all connections with the mains with particular caution!
z
Make sure that the available voltage is not higher than stated on the rear
panel.
Always plug in the power plug least. Make sure that the power-switch is set to
z
off-position before you connect the device to the mains. The power-plug has
to be accessed after installing the device.
z
Make sure that the power-cord is never crimped or damaged by sharp edges.
Check the device and the power-cord from time to time.
z
Always disconnect from the mains, when the devise is not in use or before
6
USER MANUAL
g
cleaning it. Only handle the power-cord by the plug. Never pull out the plug by
tugging the power-cord.
z It is essential to connect the yellow/green conductor to earth.
z
The electric connection, repairs and servicing must be carried out by a
qualified employee.
Do not switch the fixture on and off in short intervals as this would reduce the
z
laser diode life.
z
For replacement, please use fuses of same type and rating only.
z
If the device has been exposed to drastic temperature fluctuation, do not
switch it on immediately. The arising condensation water might damage your
device. Leave the device switched off until it has reached room temperature..
z Do not shake the device. Avoid brute force when installing or operating the
device.
When choosing the installation-spot, please make sure that the device is not
z
exposed to extreme heat, moisture or dust. There should not be any cables
lying around. You endanger your own and the safety of others!
z
The minimum distance between the fixture and surrounding walls must be
more than 50cm.
Always fix the fixture with an appropriate safety-rope. Fi x the safety-rope at
z
the safety-rope only.
z The ambient temperature must be between 10℃ to 40℃.
z
Please use the original packaging if the device is to be transported.
Please consider that unauthorized modifications on the device are forbidden
z
due to safety reasons!
CAUTION! Operate the device only after having familiarized with
its functions. Do not permit operation by persons not
qualified for operating the device. Most damages are
the result of unprofessional operation
CAUTION! If this device will be operated in any way different to the
one described in this manual, the product may suffer
dama
es and the warranty word.
7
Loading...