HP Photosmart 3310, Photosmart 3310xi Service Manual

The HP Photosmart 3100/3300 All-in-One series devices have been designed to work with the Distinctive Alert Faxability Service in New Zealand. However, in order to work, the Answer Ring Pattern for these devices must be set to Single Rings. The Single Rings option has been specifically designed to work with the Distinctive Alert Faxability Service. You can change this setting from the control panel.

Distinctive alert

faxability service

*Q5831-90178* *Q5831-90178*

Q5831-90178

Printed in [country]

To change the answer ring pattern from the control panel

Verify that your HP All-in-One is set to answer fax calls automatically. For

information, see the User Guide that came with your device.

2 Press Setup. 3 Press 4, then press 1. 4 Press!until Single Rings appears. 5 Press OK.

Additional notice

This equipment shall not be set to make a u tomatic calls to the Tel ecom ‘111’

Emergency Service.

2 This equipment should not be used under any circ umstances which may constitute a

nuisance to other Telecom customers.

3 A Teleperm it for an y terminal equipment indi cates only that Telecom accepts that the

item complies with minimum conditio ns for connection to i t s network. It indicates no endorsement of the device by Telecom, nor does it provide any sort of warranty. Above all, it does not assure that any item will work correctly with another item of Telepermitted equipment of a different make or model, nor does it imply that any device is compatible with all of Telecom’s network services.

4 The decadic (or pulse) dialing on this device is unsuitable for use on the telecom

network in New Zealand.

5 This equipment is not capable, under all operating conditions, of correct operation

at the higher speeds for which it is designed. Telecom will accept no responsibility should difficulties arise in such circumstances.

6 Not all telephones will respond to incoming ringing when connected to the

extension s ocket.

7 This device only responds to Distinctive Alerts DA1, DA2, and DA4. 8 When receiving a DA4 (Faxability) ring signal, setting the Rings to Answer to less

than 3 will result in des tro yed C aller ID informatio n if a Caller ID devi ce is connected to the same line. For information on setting the Rings to Answer , see the U se r Guide that came with your HP All-in-One.

9 When receiving fax calls from a telephone that is on the same line as the HPAll-in-

One (by pressing 1, 2, 3 on the phone), the tones generated by the telephone must be at least 65 milliseconds in duration or greater. For information, contact your telephone company or telephone manufacturer.