HP Officejet g55, Officejet g55xi Quick Setup Guide
HP OfficeJet G55 Quick Setup Poster
1
2
Install the software
a
Open the carton. Remove the HP
b
first
OfficeJet
installation
CD from the tray.
Unpack your HP OfficeJet
Turn your
computer
on and insert
the HP
OfficeJet
installation
CD.
dc e
Click to begin.Install
If the screen to the left does not
appear, go to theWindows taskbar,
click , and then choose . In
Start Run
the Run dialog box, type
(substitute your CD-ROM drive letter
for the “d”), and then click .
Follow the onscreen installation
instructions.
Note: For more information
during installation, click the
Help button, if available.
d:\setup.exe
OK
Load paper
3
When prompted
during installation,
take the Product
Tour.
View the Product
Tour to see all the
features of your
new HP OfficeJet.
After the tour,
continue to
to finish setup.
step f
f
If Windows is using any of your files
that need to be updated, Windows
will shut down during installation.
Leave your computer off until
(Configure your software).
step 10
Note: On the screen, you may be prompted to
enter your cable type.
A parallel cable is included in your carton.
However, if your PC is equipped with a USB
port and you are usingWindows 98/2000,we
recommend you purchase and use a highspeed (12Mbps) USB cable to increase
performance.
Check your PC’s documentation to determine
if you have a USB port.
4
a
Remove the tray from
the carton.
b c
Remove the print
cartridges from the sides
of the HP OfficeJet.
cartridges
Connect and secure cables and cords
a
Connect your cable.
Warning: Do not
connect the USB
cable and
parallel cable at
the same time.
Parallel Cable Users:
Connect the parallel
cable, then go to .
step b
print
- or -
Rest the box on its
side and pull out your
HP OfficeJet. Remove
any packaging or tape
from the HP OfficeJet.
USB Cable Users:
Connect the USB cable from your
HP OfficeJet to your PC, then go
step c
to .
d
d
Verify that you have
these additional key
components.
power adapter
power cord
parallel cable
a
print cartridges
b c
Parallel Cable Users:
Tighten the screws on the cable
so that it is securely attached to
your PC.
Connect the power
supply and the adapter.
3
b
c
1
5
Turn on your HP OfficeJet
6
Insert black print cartridge
a
Open the door and raise it up until it
clicks into place.The print-cartridge
carriage moves to the middle the
access area.
of
b
Raise both latches on
the print carriage.
2
Remove the black print cartridge (thinner one)
from its packaging and, being careful to touch
only the black plastic, gently remove both the
green pull tab and the blue tape covering the
nozzles.
CAUTION:
Do not touch
or remove
the goldcolored
contacts.
dc e
Push the black print cartridge
firmly down into the slot on the
right. As you insert the cartridge,
make sure the label is facing you.
Lower the right print-cartridge
latch down onto the top of the
cartridge, and push down until
the latch locks firmly into place.
http://www.hp.com/go/all-in-one
Turn page over for additional setup.
7
Insert color print cartridge
8
Remove the color print cartridge (wider
a
one) from its packaging and, being careful
to touch only the black plastic, gently
remove both the green pull tab and the
blue tape covering the nozzles.
CAUTION:
Do not touch
or remove
the goldcolored
contacts.
Select your language
Look at your display for the language list.
Enter the code for your language, and then
confirm your selection.
Keypad
Display
Push the color print cartridge firmly down into
b
the slot on the left. Lower the left print-cartridge
latch down onto the top of the cartridge, and
push down until the latch locks firmly into place.
9
Pull the handle down to close
c
the door.
Print an alignment page
Make sure paper is loaded in your
HP OfficeJet.
The message “Press to
Align Cartridges” appears in the
display.Press the key to
enable the HP OfficeJet to perform
the alignment. After a page prints,
the alignment is complete.
ENTER
ENTER
ENTER
10
Configure your software
a
Turn on your computer.Windows software
automatically configures your HP OfficeJet.
A series of Microsoft “New Hardware Found”
messages appear.The configuration may
take a few moments.
Look at the alignment page for
green check marks, and then
recycle or discard the page.
Note to USB Users: These screens may
have already appeared on your PC while you
were setting up.
Note toWindows NT 4 Users: The message,
"HP OfficeJet G Series Configuration done"
appears instead. See step b.
.If you need more help, see Chapter 1,
"Additional Setup Information" in the
Basic Guide.
b
Click to complete the software setup.
OK
If this screen does not appear, see
Chapter 1, “Additional Setup Information”
in the Basic Guide.
11
Congratulations!You can now print, copy, and scan with your new HP OfficeJet.
Additional
software
programs may
be available
with your HP
OfficeJet.
*C6736-90116*
*C6736-90116*
C6736-90116
a
To install the programs, do the
following:
Remove and reinsert
your HP OfficeJet
installation CD
in your
CD-ROM
drive.
b
The HP OfficeJet software installation
menu appears.The Productivity Section
lists additional programs you can install.
Click the program name and follow the
onscreen installation instructions.
Copyright Hewlett-Packard Company 2000.
Printed in the USA, Germany, or Singapore.
12
HP OfficeJet G55 Quick Setup Poster, Page 2
Get to know the front panel
Here are some
features of your
new HP OfficeJet:
For troubleshooting, refer to the and
the . Save this sheet for future reference.
HP OfficeJet G Series: Onscreen Guide
Use the key to make selections.ENTER
Use the key to select a specific PC or
program destination.
Use the key after you make a selection
from the Scan To list.
Use the key to access copying
features, such as Fit to Page, Poster and Clone.
Select one of these keys to begin copying.
Use the to enter the number of copies or
change the reduce/enlarge percentage.
Scan To
Start Scan
Special Features
Keypad
HP OfficeJet G Series: Your Basic Guide
Loading...