HP Officejet 5610, Officejet 5605, Officejet 5610v, Officejet 5610xi Service Manual

The HP Officejet 5600 All-in-One series devices have been designed to work with the

Distinctive Alert Faxability Service in New Zealand. However, in order to work, the

Answer Ring Pattern for these devices must be set to Single Rings. The Single Rings option

has been specifically designed to work with the Distinctive Alert Faxability Service. You

can change this setting from the control panel.

To change the answer ring pattern from the control panel

Verify that your HP All-in-One is set to answer fax calls automatically. For

information, see the User Guide that came with your device.

2 Press Setup.

3 Press 5, then press 1.

4 Press!until Single Rings appears.

5 Press OK.

Additional notice

This equipment shall not be set to make automatic calls to the Telecom ‘111’

Emergency Service.

nuisance to other Telecom customers.

item complies with minimum conditions for connection to its network. It indicates no

endorsement of the device by Telecom, nor does it provide any sort of warranty.

Above all, it does not assure that any item will work correctly with another item of

Telepermitted equipment of a different make or model, nor does it imply that any

device is compatible with all of Telecom’s network services.

2 This equipment should not be used under any circumstances which may constitute a

3 A Telepermit for any terminal equipment indicates only that Telecom accepts that the

at the higher speeds for which it is designed. Telecom will accept no responsibility

should difficulties arise in such circumstances. This condition typically applies to 56

kbits per second modems and facsimile machines operating at greater than 14.4

kbits per second.

extension socket.

4 Decadic (or pulse) dialing is not supported on this device.

5 This equipment is not capable, under all operating conditions, of correct operation

6 Not all telephones will respond to incoming ringing when connected to the

than 3 will result in destroyed Caller ID information if a Caller ID device is connected

to the same line. For information on setting the Rings to Answer, see the User Guide

that came with your HP All-in-One.

connected to the same line.

7 This device only responds to Distinctive Alerts DA1, DA2, and DA4.

8 When receiving a DA4 (Faxability) ring signal, setting the Rings to Answer to less

9 This equipment may not provide for the effective handover of a call to another device

Distinctive alert

faxability service

Q7311-90101

*Q7311-90101*

Printed in [country]