Hobart HL400 Owner’s Manual
HL400/HL600/HL800/HL1400 LEGACY ™
MIXER BOWL SCRAPER
ATTACHMENT
701 S. RIDGE AVENUE
TROY, OHIO 45374-00001
937-332-3000
www.hobartcorp.com
F 34778C (June 2009)
Installation, Operation, Use and Care
of Mixer Bowl Scraper Attachment For
HL400/HL600/HL800/HL1400 Legacy ™ Mixer
SAVE THESE INSTRUCTIONS
GENERAL
The mixer bowl scraper attachment continually scrapes the sides of the bowl as the agitator turns.
Material around the side and bottom of the bowl is constantly reintroduced into the mixture. Manual
scraping is not needed when using the bowl scraper. The bowl scraper is used when mixing batters or
creaming. The bowl scraper is not used when mixing dough products. The bowl scraper is used
only with stainless steel bowls.
INSTALLATION
UNPACKING
Immediately after unpacking, check for possible shipping damage. If any parts are found to be damaged, save the packaging material and contact the carrier within 15 days of delivery.
ASSEMBLY OF BOWL SCRAPER ONTO ARM (Figures 1 through 3)
1. Slide the food grade rubber wiper sleeve onto arm; use a little water as a lubricant to make the
sleeve slide on easier. Leading edge of scraper will turn clockwise as you look down into bowl
(g. 1).
2. If necessary, tap the end of the sleeve on a at surface to push scraper rmly.
LEADING EDGE
© HOBART 2005
Fig. 1
Fig. 2
-2-
NOTE: Always use proper size sleeve with scraper arms. Be careful not to mix sleeves and arms if
you have multiple sizes of scrapers.
INSTALL BOWL SCRAPER LABEL ON MIXER HEAD
Prepare a clean dry place on the mixer head where the bowl scraper label can be seen by the operator.
Peel off the backing paper and apply the label (Fig. 4).
Fig. 4
PL-41688-1
GUSSET
SLIDE TOP OF SLEEVE
TO LOWER GUSSET
END OF SLEEVE IS
APPROXIMATELY FLUSH
WITH METAL ARM
P L-564 27
ARMS WITH GUSSETS
SLIDE TOP OF SLEEVE
TO START OF BEND
ARMS WITHOUT GUSSETS
SLIDE SLEEVE UNTIL FLUSH
WITH END OF METAL ARM
LOCKING PIN
KEY HOLE
LOCKING PIN
KEY HOLE
LOWER GUSSET
Fig. 3
APPLY LABEL ON CLEAN FLAT SURFAC E
-3-
Loading...