Page 1
Item # _____________________________________
Quantity ___________________________________
C.S.I. Section 11400
AM SELECT TALL
701 S Ridge Avenue, Troy, OH 45374
1-888-4HOBART • www.hobartcorp.com
STANDARD FEATURES
■ .74 gallons per rack nal rinse water
■ 58 racks per hour – hot water sanitizing
■ 65 racks per hour – chemical sanitizing
■ NSF pot and pan listed for 2-, 4- & 6- minute
cycles
■ Timed wash cycles for 1, 2, 4 or 6 minutes
■ 27" door opening for 18" x 26" sheet pans or
60 quart mixing bowl
■ Solid state, integrated controls with digital status
indicators
■ Self-draining, high efciency stainless steel pump
and stainless steel impeller
■ Stainless steel drawn tank, tank shelf, chamber,
trim panels, frame and feet
■ Spring counterbalanced chamber with
polyethylene guides
■ Revolving, interchangeable upper and lower
anti-clogging wash arms
■ Revolving, interchangeable upper and lower
rinse arms
■ Slanted, self-locating, one-piece scrap screen
and basket system
■ Automatic ll
■ Door actuated start
■ Automatic drain closure
■ Vent fan control
■ External booster activation
■ Delime cycle
■ Service diagnostics
■ NAFEM Data Protocol capable
■ Straight-through or corner installation
■ Hot water or chemical sanitation
■ Sheet pan rack
DISHWASHER
MODEL
❑ AM15T
OPTIONS AT EXTRA COST
❑ Gas heat
❑ Sense-A-Temp™ 70°F rise electric booster heater
❑ Single point electrical connection for booster
equipped machines (3 phase only)
ACCESSORIES
❑ 3⁄4" pressure regulator valve
❑ Peg rack
❑ Combination rack
❑ Sheet pan rack
❑ Splash shield for corner installations
❑ Flanged and seismic feet
❑ End of cycle audible alarm (eld activated)
❑ Delime notication (eld activated)
❑ Drain water tempering kit
Specications, Details and Dimensions on Inside and Back.
AM SELECT TALL DISHWASHER
VOLTAGE
❑ 208-240/60/1
❑ 208-240/60/3
❑ 480/60/3
❑ 200-240/50/3*
❑ 380-415/50/3*
*Not submitted for UL/CUL Listing
F-40079 – AM Select Tall Dishwasher Page 1 of 8
Page 2
AM SELECT TALL
DISHWASHER – ELECTRIC
701 S Ridge Avenue, Troy, OH 45374
1-888-4HOBART • www.hobartcorp.com
Page 2 of 8 F-40079 – AM Select Tall Dishwasher
Page 3
AM SELECT TALL
701 S Ridge Avenue, Troy, OH 45374
1-888-4HOBART • www.hobartcorp.com
DISHWASHER – ELECTRIC
F-40079 – AM Select Tall Dishwasher Page 3 of 8
Page 4
AM SELECT TALL
DISHWASHER – GAS
701 S Ridge Avenue, Troy, OH 45374
1-888-4HOBART • www.hobartcorp.com
Page 4 of 8 F-40079 – AM Select Tall Dishwasher
Page 5
AM SELECT TALL
701 S Ridge Avenue, Troy, OH 45374
1-888-4HOBART • www.hobartcorp.com
DISHWASHER – GAS
F-40079 – AM Select Tall Dishwasher Page 5 of 8
Page 6
AM SELECT TALL
DISHWASHER
ELECTRIC TANK HEAT
701 S Ridge Avenue, Troy, OH 45374
1-888-4HOBART • www.hobartcorp.com
GAS TANK HEAT
AM Select Tall
Hot Water
Machine Ratings (Mechanical)
Racks per Hour (Max.)
Dishes per Hour (Average 25 per rack) 1,459 1,625
Glasses per Hour (Average 45 per rack) 2,610 2,925
Table to Table - Inside Tank at Table Connection (Inches) 251⁄4" 251⁄4"
Overall Dimensions - (H x W x D) (Inches) 77.5" x 27" x 28.5"
Wash Motor H.P. 2 2
Wash Tank Capacity - Gallons 14 14
Wash Pump Capacity - Gallons per Minute - Weir Test 160 160
Heating Equipment - (For keeping power wash water hot)
Gas Burner (Regulated) Natural/LP Gas BTU/Hr.
Electric Heating Unit (Regulated) 5 kw 5 kw
Rinse - Minutes operated during hour of capacity operation 9.66 10.83
Seconds of rinse per rack 10 10
Rate of Rinse Flow - Gallons per Minute - at 20 lbs. Flow Pressure 4.4 4.4
Rinse Consumption - Gallons per Hour - Maximum - at 20 lbs. Flow Pressure 42.9 48.1
Rinse Cycle - Gallons per Rack - at 20 PSI Flow .74 - 180°F Min. .74 - 140°F Min.
Steam Booster, if used based on 20 PSI steam - 20 PSI water owing
130°F entering water raised to 180°F min. (50°F rise) - Lbs. per Hour
Peak Rate of Drain Flow - Gallons per Minute (Initial rate with full tank) 14 14
Exhaust Requirements 450 450
Shipping Weight Crated - Approx. lbs. - Unit only, with booster
Sanitizing
58 65
25,000 25,000
40 40
388 w/o Booster
418 w/Booster
Chemical
Sanitizing
388
Page 6 of 8 F-40079 – AM Select Tall Dishwasher
Page 7
AM SELECT TALL
701 S Ridge Avenue, Troy, OH 45374
1-888-4HOBART • www.hobartcorp.com
DISHWASHER
F-40079 – AM Select Tall Dishwasher Page 7 of 8
Page 8
AM SELECT TALL
DISHWASHER
The microcomputer-based control system is built into the
AM Select dishwasher. It is available in standard electrical
specications of 208-240/60/1, 208-240/60/3, 480/60/3,
200-240/50/3, 380-415/50/3 and is equipped with a reduced
voltage pilot circuit transformer.
*CAUTION: CERTAIN MATERIALS, INCLUDING SILVER,
ALUMINUM AND PEWTER ARE ATTACKED BY SODIUM
HYPOCHLORITE (LIQUID BLEACH) IN THE CHEMICAL
SANITIZING DISHWASHER MODE OF OPERATION. WATER
HARDNESS MUST BE CONTROLLED TO 4-6 GRAINS FOR
BEST RESULTS.
CONSTRUCTION: Drawn tank, tank shelf and feet constructed
of 16 gauge stainless steel. Wash chamber and front trim panel
above motor compartment are polished, satin nish. Frame is
12 gauge stainless steel, chamber is 18 gauge, and removable
trim panels are 20 gauge.
CHAMBER: Stainless steel chamber with large 203⁄4" W x 27" H
opening will accommodate 18" x 26" sheet pans or a 60-quart
mixing bowl.
CHAMBER LIFT: Chamber coupled by stainless steel handle,
spring counterbalanced. Chamber guided for ease of operation
and long life.
PUMP: With stainless steel pump and impeller, integral with
motor assures alignment and quiet operation. Pump shaft seal
with stainless steel parts and a carbon ceramic sealing interface.
Easily removable impeller housing permits ease of inspection.
Capacity 160 GPM. Pump is completely self-draining.
MOTOR: Built for Hobart, 2 H.P., with inherent thermal
protection, grease-packed ball bearings, splash-proof design,
ventilated. Single-phase is capacitor-start, induction-run type.
Three-phase is squirrel-cage, induction type.
MICROCOMPUTER CONTROL SYSTEM: Hobart microcomputer controls, assembled within water-resistant enclosure,
provide built-in performance and reliability.
The microcomputer control, relays and contactors are housed
behind a stainless steel enclosure, hinged to provide easy
access for servicing. The line voltage electrical components are
completely wired with 105°C, 600V thermoplastic insulated wire
with stranded conductors and routed through listed electrical
conduit. Electrical components are wired with type ST cord.
Line disconnect switch NOT furnished.
CYCLE OPERATION: The microcomputer-timing program is
started by closing the doors, which actuates the door cycle
switch. The microcomputer energizes the wash pump motor
contactor during the wash portion of the program. After the
wash, a dwell permits the upper wash manifold to drain. At the
end of the dwell, the nal rinse solenoid valve is energized.
After the nal rinse valve closes, Sani-Dwell (Hot Water Mode
only) permits sanitization to continue. The Rinse display remains
on during this period, completing the program. If the microcomputer is interrupted during a cycle by the door-cycle switch,
the microcomputer is reset to the beginning of the program.
Hot Water Sanitizing (58 racks per hour) – 57 seconds: 38
Second Wash, 2 Second Dwell, 10 Second Rinse, 7 Second
Sani-Dwell. Chemical Sanitizing (65 racks per hour) – 50
Seconds: 38 Second Wash, 2 Second Dwell, 10 Second Rinse.
Other programs can be pre-selected by your Hobart service
technician.
As continued product improvement is a policy of Hobart, specications are subject to change without notice.
701 S Ridge Avenue, Troy, OH 45374
1-888-4HOBART • www.hobartcorp.com
Manual wash cycle selector also provides selection of 2-, 4- or
6-minute wash cycles for heavier washing applications.
WASH: Hobart revolving stainless steel wash arms with
unrestricted openings above and below provide thorough
distribution of water jets to all dishware surfaces. Arms are easily
removable for cleaning and are interchangeable. Stainless steel
tubing manifold connects upper and lower spray system.
RINSE: Rotating rinse arms, both upper and lower, feature
14 rinse nozzles. The stainless steel upper and lower rinse arms
are easily removable without tools for inspection and are
interchangeable. Diaphragm-type rinse control solenoid valve
mounted outside machine. Machine is equipped with special hot
water vacuum breaker on downstream side of rinse valve –
mounted 6" above uppermost rinse opening. Easy open brass
line strainer furnished.
FILL: Microcomputer controlled ll valve installed on upstream
side of rinse vacuum breaker. Ratio ll method is used giving the
correct ll at any owing water pressure. (20 PSIG minimum
necessary for proper rinsing.)
DRAIN AND OVERFLOW: Large bell type automatic overow
and drain valve controlled from inside of machine. Drain
automatically closed by lowering chamber. Drain seal is large
diameter, high temperature “O” ring. Cover for overow is
integral part of the stand pipe.
STRAINER SYSTEM: Equipped with large, exclusive selfushing, easily removable perforated stainless steel, one-piece
strainer and large capacity scrap basket. Submerged scrap
basket minimizes frequent removal and cleaning.
HEATING EQUIPMENT: Standard tank heat is 5KW electric
immersion heating element. Regulated power infrared gas
immersion tube system is optional at extra cost. A solid-state
igniter board controls the gas valve and provides ame ignition.
A transformer steps the control circuit voltage down to 24 volts
to power the igniter board and gas valves.
Gas Heated Dishwasher: For natural gas, gas pressure
(customer connection) not to exceed 7" W.C. For liqueed
petroleum, gas pressure to burner (customer connection) not to
exceed 11" W.C. If gas pressure is higher than 7" W.C. natural or
11" W.C. LP, a pressure regulating valve must be supplied (by
others) in the gas line to the dishwasher. Water temperature
regulation is controlled by thermistor sensor in combination with
microcomputer controls. The tank heat and positive low water
protection microcomputer circuits are automatically activated
when the main power switch is turned “on”. If tank is accidentally
drained, low water protection device automatically turns heat
off. Gas immersion tube is additionally protected by a high limit
device mounted on the surface of the tube. These features are
standard with the Hobart Microcomputer Control System.
OPTIONAL EQUIPMENT AT EXTRA COST – ELECTRIC
BOOSTER HEATER: Electric booster with Sense-A-TempTM
technology adequately sized to raise 110°F inlet water to 180°F
(not available on gas heat machines).
ACCESSORIES: 193⁄4" x 193⁄4" peg and combination dish racks.
Sheet pan rack. Splash shield for corner installations. End of
cycle audible alarm (eld activated). Delime notication (eld
activated). Desirable functional accessories can be furnished
at added cost. See listed options and accessories on this
specication sheet. Write to the factory for special requirements
not listed above.
Page 8 of 8 F-40079 – AM Select Tall Dishwasher
F-40079 (REV. 05/11) LITHO IN U.S.A. (H-01)
Loading...