Haier HSU-12HEA03, HSU-108HEA03, HSU-09HEA03, HSU-138HEA03 Manual

0 (0)

SPLIT TYPE ROOM AIR CONDITIONER

OPERATION MANUAL

HSU-108HEA03

HSU-108HEA03-M

HSU-108HEA03-S

HSU-138HEA03

HSU-138HEA03-M

HSU-138HEA03-S

Please read this operation manual before using the air conditioner.

0010518766

Cautions

Disposal of the old air conditioner

Safety Instructions and Warnings

Before disposing an old air conditioner that goes out of use, please make sure it's inoperative and safe. Unplug the air conditioner in order to avoid the risk of child entrapment.

It must be noticed that air conditioner system contains refrigerants, which require specialized waste disposal. The valuable materials contained in an air conditioner can be recycled

.Contact your local waste disposal center for proper disposal of an old air conditioner and contact your local authority or your dealer if you have any question. Please ensure that the pipework of your air conditioner does not get damagedprior to being picked up by the relevant waste disposal center, and contribute to environmental awareness by insisting on an appropriate, anti-pollution method of disposal.

Disposal of the packaging of your

Before starting the air conditioner, read the information given in the User's Guide carefully. The User's Guide contains very important observations relating to the assembly, operation and maintenance of the air conditioner.

The manufacturer does not accept responsibility for any damages that may arise due to non-observation of the following instruction.

Damaged air conditioners are not to be put into operation. In case of doubt, consult your supplier.

Use of the air conditioner is to be carried out in strict compliance with the relative instructions set forth in the User's Guide.

Installation shall be done by professional people, don't install unit by yourself.

new air conditioner

All the packaging materials employed in the package of your new air conditioner may be disposed without any danger to the environment.

The cardboard box may be broken or cut into smaller pieces and given to a waste paper disposal service. The wrapping bag made of polyethylene and the polyethylene foam pads contain no fluorochloric hydrocarbon.

All these valuable materials may be taken to a waste collecting center and used again after adequate recycling.

Consult your local authorities for the name and address of the waste materials collecting centers and waste paper disposal services nearest to your house.

For the purpose of the safety,the air conditioner must be properly grounded in accordance with specifications.

Always remember to unplug the air conditioner before openning inlet grill. Never unplug your air conditioner by pulling on the power cord. Always grip plug firmly and pull straight out from the outlet.

All electrical repairs must be carried out by qualified electricians. Inadequate repairs may result in a major source of danger for the user of the air conditioner.

Do not damage any parts of the air conditioner that carry refrigerant by piercing or performating the air conditioner's tubes with sharp or pointed items, crushing or twisting any tubes, or scraping the coatings off the surfaces. If the refrigerant spurts out and gets into eyes, it may result in serious eye injuries.

1

&DXWLRQV

'R QRW REVWUXFW RU FRYHU WKH YHQWLODWLRQ JULOOH RI WKH DLU FRQGLWRQHU 'R QRW SXW ILQJHUV RU DQ\ RWKHU WKLQJV LQWR WKH LQOHW RXWOHW DQG VZLQJ ORXYHU

'R QRW DOORZ FKLOGUHQ WR SOD\ ZLWK WKH DLUFRQGLWLRQHU ,Q QR FDVH VKRXOG FKLOGUHQ EH DOORZHG WR VLW RQ WKH RXWGRRU XQLW

6SHFLILFDWLRQV

7KH UHIULJHUDWLQJ FLUFXLW LV OHDN SURRI

7KH PDFKLQH LV DGDSWLYH LQ IROORZLQJ

VLWXDWLRQ

$SSOLFDEOH DPELHQW WHPSHUDWXUH UDQJH

7KH DSSOLDQFH LV QRW LQWHQGHG IRU XVH E\ \RXQJ FKLOGUHQ RU LQILUP SHUVRQV

ZLWKRXW VXSHUYLVLRQ

<RXQJ FKLOGUHQ VKRXOG EH VXSHUYLVHG

WR HQVXUH WKDW WKH\ GR QRW SOD\ ZLWK

WKH DSSOLHQFH

3OHDVH HPSOR\ WKH SURSHU SRZHU SOXJ

ZKLFK ILW LQWR WKH SRZHU VXSSO\ FRUG

7KH SRZHU SOXJ DQG FRQQHFWLQJ FDEOH PXVW KDYH DFTXLUHG WKH ORFDO DWWHVWDWLRQ

,Q RUGHU WR SURWHFW WKH XQLWV SOHDVH WXUQ

RII WKH $ & ILUVW DQG DW OHDVW VHFRQGV

ODWHU FXWWLQJ RII WKH SRZHU

 

,QGRRU

0D[LPXP '% : % R& R&

&RROLQJ

0LQLPXP '% : % R& R&

2XWGRRU

0D[LPXP '% : % R& R&

 

0LQLPXP '%

R&

,I WKH SRZHU VXSSO\ FRUG LV GDPDJHG LW PXVW EH UHSODFHG E\ WKH PDQXIDFWXUHU

RU LWV VHUYLFH DJHQW RU D VLPLODU TXDOLILHG

SHUVRQ

,I WKH IXVH RI LQGRRU XQLW RQ 3& ERDUG LV

EURNHQ SOHDVH FKDQJH LW ZLWK WKH W\SH RI 7 $ 9

7KH ZLULQJ PHWKRG VKRXOG EH LQ OLQH ZLWK

WKH ORFDO ZLULQJ VWDQGDUG

$IWHU LQVWDOODWLRQ WKH SRZHU SOXJ VKRXOG

EH HDVLO\ UHDFKHG

7KH ZDVWH EDWWHU\ VKRXOG EH GLVSRVHG

SURSHUO\

Parts and Functions

Indoor Unit

Display board

Inlet

Air Purifying Filter

(inside)

Inlet grille

Horizontal flap

(adjust up and down air flow. Don't adjust it manually)

Outlet

Air filter(inside)

Power plug

Anion generator

(inside)

Vertical blade

(adjust left and right air flow)

Actual inlet grille may vary from the one shown in the manual according to the product purchased

Outdoor Unit

HSU-108HEA03 HSU-138HEA03

HSU-108HEA03-M HSU-138HEA03-M

HSU-108HEA03-S HSU-138HEA03-S

OUTLET

CONNECTING PIPING AND ELECTRICAL WIRING

INLET

DRAIN HOSE

3

Haier HSU-12HEA03, HSU-108HEA03, HSU-09HEA03, HSU-138HEA03 Manual

Parts and Functions

 

Remote controller

 

Display board

1

 

 

 

 

6

 

 

 

 

 

2

 

 

 

 

7

A

o

ON

OFF

8

3

T

AM

 

U

 

 

O

C PM

 

9

4

 

 

 

 

10

 

 

 

 

 

 

ON/OFF

TEMP

 

11

 

 

5

12

 

 

 

 

 

 

 

 

19

 

MODE

 

SET

 

 

 

13

20

 

FAN

TIMER

14

21

15

CLOCK

SWING

16

22

 

HEALTH POWER/SOFT

 

17

LOCK

24

RESET

18

23

25

1

26

4

1

8

9

5

7.SIGNAL SENDING display

8.TIMER OFF display

9.TIMER ON display

10.CLOCK display

11.TEMP display

12.POWER ON/OFF

Used for unit start and stop.

13.MODE

Used to select COOL,DRY operation

14.FAN

Used to select fan speed AUTO, HI, MED, LO

15.HOUR

Used to set clock and timer setting.

16.SWING

Used to set auto fan direction.

17.POWER/SOFT button

18.LOCK

Used to lock buttons and LCD display.

19.TEMP.

Used to select your desired temp.

20.SET

1. Operation mode display

Operation mode COOL DRY

Remote controller

Display board

2. SWING display

 

 

 

 

 

 

 

 

3. FAN SPEED display

 

 

 

 

 

 

 

 

 

AUTO HI MED LO

4. HEALTH display

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

5. POWER/SOFT display

6. LOCK display

Used to confirm timer and clock settings.

21.TIMER

Used to select TIMER ON, TIMER OFF,

22.CLOCK

Used to set correct time

23.RESET

Used to reset the controller back to normal condition.

24.HEALTH

Used to operate the healthy function

25.Singal receiver hole

26.Ambient temp.display

When receiving the remote control signal, display the set temperature and in the rest time the room temperature is displayed and this room temperature is only for reference.

Clock set

When unit is started for the first time and after replacing batteries in remote controller, clock should be adjusted as follows:

Press CLOCK button, "AM" or "PM" flashes.

Press or to set correct time. Each press will increase or decrease 1min. If the button is kept depressed, time will change quickly.

After time setting is confirmed, press SET, "AM "and "PM" stop flashing, while clock

starts working.

NOTE: Cooling only unit do not have displays and functions related with heating The unit do not have functions related with healthing

Hints

After replacing with new batteries, remote controller will conduct self-check, displaying all information on LCD. Then, it will become normal.

4

Operation

Remote controller's operation

When in use, put the signal transmission head directly to the receiver hole on the indoor unit.

The distance between the signal transmission head and the receiver hole should be within 7m without any obstacle as well.

Don't throw the controller, prevent it from being damaged.

When electronic-started type fluorescent lamp or change-over type fluorescent lamp or wireless telephone is installed in the room, the receiver is apt to be disturbed in receivering the signals so the distance to the indoor unit should be shorter.

Loading of the battery

Load the batteries as illustrated. 2 R-03 batteries, resetting key (cylinder)

Remove the battery cover:

Slightly press " " and push down the cover.

Load the battery:

Be sure that the loading is in line with the" + "/"-"

pole request as illustrated.

Put on the cover again Confirmation indicator:

In disorderation, reload the batteries or load the new batteries after 6mins.

Note:

Use two new same-typed batteries when loading.

If the remote controller can't run normally or doesn't work at all, use a sharp pointed item to press the reset key.

Hint:

Remove the batteries in case unit won't be in usage for a long period. If there are any display after taking-out just need to press reset key.

Power failure resume(please set and apply as necessary)

If sudden power failure occurs, the unit will resume original operation when power is supplied again.

Note to the power failure resume:

press the health button ten times in five seconds and enter this function after hearing four sounds. And press the health button ten times within five seconds and leave this function after hearing two sounds.

Note: When sudden power failure happens during unit operation in power failure resume mode, if the air conditioner is not desired for use in a long period, please shut off the power supply in case that the unit automatically resume operation when power is re-supplied, or press ON/OFF to turn off the unit when power resumes.

5

Loading...
+ 12 hidden pages