Groen SSB-10GF User Manual

PROJECT NAME:

LOCATION:

SMARTSTEAM100 BOILERLESS STEAMER

MODEL (2)SSB-10GF

Steamer shall be a Groen Model (2)SSB-10GF SmartSteam100™ stainless steel,
boilerless, convection steamer. Each steamer cavity shall have a self-contained
atmospheric 100,000 BTU/hr gas steam generating reservoir.

CONSTRUCTION: Steamer cavity, cabinet and stand

shall be all stainless steel construction, with removable
right and left-side panels, providing access to internal
components. Steamer shall have no side vents for increased
water/spray resistance. Steamer cavities shall accommodate
18 x 26” bake pans. Steamer doors shall be all stainless
steel with a strong continuous hinge and field-reversible for
left or right swing. Doors shall be insulated and provided
with a one-piece, replaceable seal. Easy-open door handles
and latches shall provide positive lock and seal when doors
are pushed or slammed shut. A hidden magnetic door switch
shall cut power to blower fan and shut down power to the
steam generating reservoir when a door is opened. Pan
support racks shall be stainless steel and removable for easy
cleaning. A stainless steel condensate collection tray shall be
positioned under each cavity door.

FINISH: Cabinet exterior, including door, shall be a #3

uniform finish. Cavity interior shall be polished stainless
steel. Control panel face plate shall be smudge-resistant
polyester film, ensuring maximum ease in cleaning and
maintenance of an attractive appearance.

CSA LISTING: Steamer shall be CSA (formerly CGA)

design certified

SANITATION: Steamer shall be designed and

manufactured to meet NSF requirements and all known
health codes. Steamer shall be NSF listed.

CONTROLS: Steamer controls shall include an on-off

rocker switch; electronic timer, with continuous steam, timed
steam and stop buttons; READY light which indicates when
cavity is warm and ready for steaming.

PERFORMANCE FEATURES: Each steamer

cavity shall have a powerful, side-mounted blower to
increase steam velocity and provide efficient steam
distribution throughout the cavity and between loaded pans.
Steam generators shall deliver 100,000 BTU/hr of power
input per 2-1/2” deep steam pan. Steamer shall have a
steam lid positioned over each steam generating reservoir
to ensure that adding/removing food does not lower the

cavity or water temperature. Heat up time to READY shall
typically be 15 minutes or less. Cavity is kept warm and
ready for instant steam between loads. No cavity warm
up required after READY light comes on.

ATMOSPHERIC STEAM GENERATING
RESERVOIR:

heated steam generating reservoir to provide atmospheric
steam to the cavity at a temperature of approximately
212° F. The high-efficiency steam generating reservoirs
shall have water sensors. Gas heaters shall have infrared
burners with a firing rate of 100,000 BTU/hr. Acidic
products and other commercial chemicals shall not be
used to clean the steamer. A daily wipe down of the
steamer cavity, steam lid and water probes is sufficient
to maintain optimal operation of the steamer. However,
Groen Descaler or approved equal may be required.

Each steamer shall have a gas-

PAN CAPACITY:

Pan Size/ Type Total Total

12 x 20 x 1” 20 40

12 x 20 x2 1/2” 10 20

12 x 20 x 4” 6 12

13 x 18 bake pan 20 40

18 x 26 bake pan 10 20

INSTALLATION: Steamer shall require natural or

propane (specify) gas service via a 1/2” NPT gas supply
line, or approved equivalent. Steamer shall be connected
to a ¾” NH cold water supply line and a 2” free venting
drain. Steamer shall require two 115 Volt, single-phase
electrical service connections.

WATER SUPPLY REQUIREMENTS:

Steamer must be connected to an on-site water supply.
Water supply at 30 to 60 PSIG with flow at .75 - 1.5
GPM per cavity.

ORIGIN OF MANUFACTURE: Designed and

manufactured in the United States.

ITEM NO:

QTY:

MODEL NO:

AIA NO:

SIS NO:

SHORT FORM: 20-Pan

Boilerless Convection Steamer (10
pans per cavity), double-stacked,
stand-mounted, stainless steel, self­contained, gas heated.
(Model (2)SSB-10GF shown)

OPTIONS/ACCESSORIES:

Flanged Foot Kit (for support

stand)
Caster Kit (for support stand)
High Altitude Kit (above 2000’,

specify)
Heat Shield Kits

SmartSteam100

146576F Revised 08/13

20-Pan Boilerless Convection Steamer (10 pans per cavity), double­stacked, stand-mounted, stainless steel, self-contained, gas heated.

P/N 146528 REV E

(2)SSB-10GF

P/N 146346 REV E

1055 Mendell Davis Drive, Jackson, MS 39272, 888-994-7636, unifiedbrands.net

© 2013 Unified Brands. All Rights Reserved. Unified Brands is a wholly-owned subsidiary of Dover Corporation.