Gigaset L410 User Guide

Gigaset L410 – Freedom of movement while phoning

Using the practical handsfree clip you can speak on the telephone for hours in comfort – with outstanding sound quality. Your Gigaset L410 expands the possibilities of your cordless telephone:

Enjoy full freedom of movement while phoning

Attach the Gigaset L410 to your clothing and move around as you wish while phoning. You can then be reached anywhere at home or in the office and keep your hands free while phoning – without any annoying cables.

Operate the device at the touch of a button

Are you moving around the house and want to take an incoming call? Or do you want to transfer a call on a handset to your handsfree clip? All you need to do is press one key and you’ll be connected with the caller.

Hold a three-way conference

A family member is making a call and you would like to participate. Simply join in on the existing call and talk on the telephone together.

Adjust the volume of the Gigaset L410 to your surroundings

Regulate the volume of the loudspeaker and ringtone by simply pressing a key – five volume levels are available. You can also switch off the ringtone completely.

Environment

Environmentally-aware telephone calls – Gigaset Green Home. You can find details on our ECO DECT products at www.gigaset.com/service

Further information is available online at www.gigaset.com/gigasetl410

Please register your Gigaset device immediately after purchase, at

www.gigaset.com/service have any questions or need to make a claim on the guarantee!

Have lots of fun with your new handsfree clip!

– this will enable us to help you more quickly if you

Overview

Loudspeaker

Volu me keys /

Setting the volume of the

*For example, this function is available on the following telephones: Gigaset C610/C610A, Gigaset

S810/S810A and Gigaset SL400/SL400A (see also ww w.gigaset.com/compatibility).

Light indicator (LED)

Prior to regis tration

Green flashing 3 x per second Ready to register

After registration

Green flashing every 5 seconds Registered and on stand-by Red flashing every 5 seconds Battery charge low Red lit continuously Battery is charging Green lit continuously Battery is fully charged

Operating mode display

Green flashing long, 1 x per second Incoming call Green flashing long, every 5 seconds Ongoing call Red flashing 1 x per second Registered, but outside the range of your base

loudspeaker and the ringtone.

Answer/End call key

Press briefly :

Accept call, take over call

Hold down:

Join in on a call

Hold for more than 3 seconds:

Switch device on/off

Light indicator (LED)

Microphone

Charging connection

, end call

(device in the charging cradle)

£ page 11

£ page 7

£ page 9

£ page 10

Safety precautions

War ning

Read the safety precautions and the user guide before use. Explain their content and the potential hazards associated with using the telephone to your children.

Use only rechargeable batteries that correspond to the specification provided on page 13, as this could otherwise result in significant health risks and personal injury. At the end of the battery's life, the technology will cause the battery to thicken and it may develop a convex curve. In this case, the device will no longer function perfectly. If this occurs, please replace the battery with an original replacement battery (Gigaset V30145-K1310-X448) and dispose of the old battery. Always handle the battery with care, do not damage the casing with sharp objects and do not exert any great pressure on the battery.

Using your telephone may affect nearby medical equipment. Be aware of the technical conditions in your particular environment, e.g., doctor's surgery. If you use a medical device (e.g. a pacemaker), please contact the device manufacturer.

of the device to external sources of high frequency energy. Please refer to

Appendix chapter for the specifications of this Gigaset product.

the

Do not hold the handset to your ear, as doing so could result in serious, lasting hearing damage. Your Gigaset is compatible with the majority of digital hearing aids on the market. However, we cannot guarantee that the device will function perfectly with every hearing aid. The handset may cause disruptive noises (humming or whistling) in analogue hearing aids, or override these. Please contact your hearing aid technician in the event of problems.

Do not install the charger in bathrooms or shower rooms. The device is not splashproof.

Do not use the phone in environments with a potential explosion hazard, e.g., paint shops.

If you give your phone to a third party, make sure you also give them the user guide.

Remove faulty devices from use or have them repaired by our Service team, as they could interfere with other wireless services.

They will be able to advise you regarding the susceptibility

The Gigaset L410

Gigaset L410 is a handsfree clip for cordless telephones. You attach it to your clothing in order to enjoy complete freedom of movement while on the telephone. The Gigaset L410 is registered to a Gigaset base or a DECT base from another manufacturer. Depending on your base, you can register multiple Gigaset L410 and use them to make internal, external or conference calls.

Prerequisite: Any base from a different manufacturer must be GAP-compatible (see enclosed documentation). GAP (Generic Access Profile) is a standard for the interoperation of handsets and bases from different manufac turers. Information on the range of functions available on various telephones can be found in the section Compatibility (£ page 13).

Getting started

Check the contents of the package

u Gigaset L410 u Battery u Battery cover with clip

u Charging cradle with mains plug u These instructions for use

Setting up the Gigaset L410

Insert battery

¤ Plug the battery connector into

the bottom right socket in the casing (see arrow).

The red cable on the connector is located on the side of the casing marked with +, the black cable on the side marked with –..

¤ Place the battery into the casing.

The foam cushion on the battery must face upwards. Please ensure that the cables lie between the battery and the casing and not under the battery.

Closing the battery cover

¤ Insert the cover at the bottom end

of the casing.

To open the cover again:

¤ Close the cover and apply pressure

until it locks into place.

Catch

¤ Loosen the catch and lift the cover upwards.

Registering the device with the base

In order to telephone using your Gigaset L410, it must be registered with your telephone’s base. If you purchased the device in a set with a Gigaset telephone, it is already registered.

Note

The Gigaset L410 uses 0000 as its PIN for registration. When you have set another PIN on your base, you must reset this to 0000 to enable registration of the L410. After registration you can change the PIN again.

As soon as you have inserted the battery, the device becomes ready for registration for a 5 minute period. The LED i ndicates readiness for registration by flashing (green, 3 x per second).

Following this, the device switches off. When you switch the device on again (by pressing the answer/end call key for at least 3 seconds) it is ready for registration again.

¤ For registration, stand close to your telephone’s base. ¤ Start the registration process with the base as described in your base’s

operating instructions (on most DECT telephones by holding down the paging key); the base will take up to one minute to complete registration.

Device successfully registered

u The LED flashes (green, every 5 seconds) and one confirmation tone is emitted

(sequence of tones rising in pitch).

u The device is shown in the internal list of handsets registered to the base.

On telephones that support the full range of functions ( with the name L410. If more than one Gigaset L410 is registered, a number is appended to the name (L410-2, L410-3, etc.).

On other telephones: with the internal device name (e.g. INT 1, INT 2, etc.)

£ page 13):

Registration failed

u A negative confirmation tone is emitted (sequence of tones falling in pitch). u If the device cannot be registered within 5 minutes, it switches off.

If the registration was not successful, try again.

¤ If necessary, switch on the device again. It is immediately ready for registration. ¤ Check whether the registration PIN on the base is set to 0000. ¤ Move closer to the base with the Gigaset L410. ¤ If the device is already registered to another base, you must de-register it

£ page 10). Following this, it will be ready for registration again.

(

Securing the clip

¤ Attach the Gigaset L410 to

your clothing using the clip.

Optimal distance from your mouth: 20 cm

Charging the battery

When delivered, the battery is partly charged. When the device is registered and on stand-by, the charge status is shown as follows:

Device Battery status LED

In the charging cradle Fully charged Steady green light.

Not in the charging cradle

In all other operating conditions, ( means of the LED.

When the battery is almost empty, a signal tone is always emitted, 1 x per min.

To charge the battery:

Charging Steady red light. Sufficient charge Flashes green, every 5 seconds Almost empty Flashes red, every 5 seconds

£ page 2) the charge status is not displayed by

¤ Connect the charging cradle to the mains

power and place the device in the charging

cradle . It will be fully charged within 2.5 hours. You can interrupt the charging procedure.

Note: If you place the device in the charging cradle during a call, this will not disconnect the call.

Phoning

With your Gigaset L410 you can accept calls, take over calls or join in on a call. You can call the Gigaset L410 internally from a handset, call back internally, or connect a call.

Accepting a call

An incoming call is indicated by a ringtone and an LED light.

¤ Press Answer/End call key.

Ending a call

¤ Press Answer/End call key.

Making a call/taking over a call

In order to start an external call, dial the telephone number on the handset. You can take over the call on the Gigaset L410 as soon as you have started dialling or when the connection is established.

¤ Press Answer/End call key.

For example, this function is available on the following telephones: Gigaset C610/C610A, Gigaset S810/S810A and Gigaset SL400/SL400A (see also www.gigaset.com/compatibility).

Note

On other telephones, you must transfer the call from the handset to the Gigaset L410.

Handset:

¤ Call the Gigaset L410 on an internal line (with Gigaset

telephones, press the Int key to do so, where necessary, select the Gigaset L410 from the list of handsets registered, press Answer call key).

¤ End the external call by pressing the End call key.

Gigaset L410:

¤ Press the Answer/End call key to take over the call.

+ 14 hidden pages