Title:
CC848817445: Instructions for QS873A Thermal Probe Expansion Kit
(For use with Kit CC109135027: 3EM21240AA)
Change History:
Name: Date: Revision: Description Of Change
KAL 1/24/2007 1 INITIAL RELEASE
KAL 3/28/2007 2 REPLACE 848719811 WITH CC848822321 (RoHS EQUIVALENT)
PDS 3/31/08 3 Lineage Power Version
Required Tools:
Wrench required to loosen/tighten hardware on battery posts. The size of this wrench is dictated by the batteries.
Procedure:
1. Verify all material is in kit.
Qty 1 108987611 QS873A Thermal Probe Assembly
Qty 1
Qty 1 402244081 Cable Tie (Attached)
Qty 2 848715074 Case (1 Attached & 1 Loose Spare)
2. Select the last thermal probe in the existing thermal probe daisy chain. This is the probe where the Thermal Probe Expansion
Kit will connect. If this existing probe can be disconnected from its battery during installation of the expansion kit, this will
make the process easier.
3. On the existing thermal probe, cut the cable tie (strain relief) and open the case (if case is damaged during opening, a spare is
provided in the expansion kit). Do not unplug existing wireset. See Figure 1.
CC848822321 Wireset (Pre-attached to
Thermal Probe)
FIGURE 1: Opening Thermal Probe Case
Doc ID: CC848817445-MAN 1 OF 3 3/31/2008
Doc Type: General Manual 11:14:34 AM
Doc Issue: See change history above Lineage Power
Proprietary - Use Pursuant To Company Instructions
4. Plug the end of the wireset from the expansion kit into the only available connector on the existing Thermal Probe as shown in
Figure 2 then snap case closed. The wires should then be cable tied back to the case for strain relief.
FIGURE 2: Daisy Chaining from Probe to Probe
5. If it was removed in step 2, reattach the existing thermal probe to its original battery. For details on how to mount to battery
see steps 7 & 8.
6. Before installing the new batteries, route the Wireset through the cabinet to the battery where the new Thermal Probe will be
connected. Use the upper left square hole as shown in the upper right view (Side 2) in Figure 3.
FIGURE 3: Thermal Probe Wireset Routing
Doc ID: CC848817445-MAN 2 OF 3 3/31/2008
Doc Type: General Manual 11:14:34 AM
Doc Issue: See change history above Lineage Power
Proprietary - Use Pursuant To Company Instructions
Loading...