GE Industrial Solutions ABB SACE Isomax S7 User Manual
ABB SACE
Isomax S7
Trip
Function
Spectra® RMS
SK
Interrupt Tier
S7
Neutral
Sensor Assembly
(CAT#)
SK
Neutral
Assembly
(CAT#)
S7H1000B0K
LI1
SKTC3408L3XX2
65kA @ 480Vac
n/a
n/a
S7H1000C0K
LSI
SKTC3408L3XX2
65kA @ 480Vac
n/a
n/a
S7H1000E0K
LSIG
SKTC3408L4XX2
65kA @ 480Vac
ANK100GFABB
ANK800GF3
S7H1200B0K
LI1
SKTC3412L3XX
65kA @ 480Vac
n/a
n/a
S7H1200C0K
LSI
SKTC3412L3XX
65kA @ 480Vac
n/a
n/a
S7H1200E0K
LSIG
SKTC3412L4XX
65kA @ 480Vac
ANK120GFABB
ANK120GF
1
GE replacements for LI breakers contain the LSI trip function (L3)
2
For 900-1000A applications, change 3408 to 3410 in center of catalog number
3
For 900-1000A applications, change 800 to 100 in the center of the Neutral catalog number
NOTE: Consult the GE
Buylog
Section 3 and Section 9 for lugs and other accessories not explicitly
mentioned in this document
GEH-709 ABB S7 Replacement Accessory List
ABB SACE Isomax S7 to
®
Spectra
A Spectra® RMS molded-case circuit breaker,
designated by an SKT Interrupt tier, may be used to
replace an ABB SACE Isomax S7 equivalent within an
installed Spectra® Series Panelboard.
RMS SK Frame
Use the Table below to match an existing ABB SACE
Isomax S7 to its equivalent Spectra® RMS moldedcase circuit breaker, based on trip function. If
applicable, neutral sensor assemblies are also listed
and should be replaced with the breaker.
The list of accessories shown below, are required to
properly install a new Spectra® RMS SK Frame into
the existing panel enclosure.
APP2W - 2X Filler Plate for 45W section (qty1 per
breaker)
AMCB3KMFP - SK mounting hardware including filler
plate, straps, and brackets (qty1 per breaker)
GTPXXXXUXX12 - Universal Rating Plugs for
microEntelliguard™ Trip Units (qty1 per breaker)
See GE Buylog or DEH-41318 for catalog details
GEH-709 ABB S7 Replacement
Accessory
List
Notes:
Spectra and MicroVersaTrip are registered
microEntelliGuard are trademarks of the General Electric Company.
These instructions do not cover all details or variations in equipment nor do they
provide for
operation, or maintenance. Should further information be desired or should particular
problems arise that are not covered
matter should be referred to the GE Company.
every
possible
contingency
trademarks
that may be met in connection with installation,
sufficiently
and EntelliGuard and
for the purchaser’s purposes, the
GE Energy
41 Woodford Avenue, Plainville, CT 06062
www.geelectrical.com
© 2012 General Electric Company
imagination at work
GEH-709 Rev. 1 (03/12)
Loading...