Garmin 02666, 02669 User Manual
Instructions
DRAFT
Introduction
WARNING
See the Important Safety and Product
Information guide in the product box for product
warnings and other important information.
Always consult your physician before you begin
or modify any exercise program.
Charging the Device
NOTICE
To prevent corrosion, thoroughly dry the USB
port, the weather cap, and the surrounding area
before charging or connecting to a computer.
The device is powered by a built-in lithium-ion
battery that you can charge using a standard
wall outlet or a USB port on your computer.
NOTE: The device will not charge when outside
the approved temperature range (page 10).
Pull up the weather cap from the USB port.
1
Plug the small end of the USB cable into
2
the USB port on the device.
Plug the large end of the USB cable into an
3
AC adapter or a computer USB port.
Plug the AC adapter into a standard wall
4
outlet.
Charge the device completely.
DRAFT
5
The status LED flashes green while charging.
The status LED is solid green when charging is
complete.
Installing the Mount
You can use the mount to install both
another® device and this device.
Select a secure location to mount another
1
device and this device where they do
not interfere with safe operation
.
Use the hex key to remove the screw
2
from the connector Á.
If necessary, remove the two screws on the
3
top of the mount Â, rotate the connector,
and replace the screws to change the
orientation of the mount for another
device.
Place the rubber pad around the
4
mount area:
• If the mount diameter is 25.4 mm,
use the thicker pad.
• If the mount diameter is 31.8 mm,
use the thinner pad.
À
2
Place the connector around the
DRAFT
5
rubber pad.
Replace and tighten the screw.
6
NOTE: Garmin® recommends a torque
specification of 7 lbf-in. (0.8 N-m). You
should check the tightness of the screw
periodically.
If installing another device, align the tabs
7
on the back of the other device with the
notches on the top of the mount Ã.
Press down slightly and the other
8
device and adjust until it locks into place.
Align the notches on the top of this
9
device with the tabs on the bottom of
the mount Ä.
Press up slightly and adjust the
10
device until it locks into place.
3
Loading...