Furuno FEA-2100 User Manual
ECDIS FEA-2100/2105
ENC Chart (Japan Maritime Safety Agency）
Update Manual
・Update chart before embarking on a voyage. Do not update charts during a voyage.
・During updating, do not display the radar overlay screen or the route monitor screen.
Hangup may result. If hangup occurs, turn the power off and on again.
・It takes about seven hours to update one zone. Plan accordingly.
[CHART PLAN] key
1. Preparation
[SENC Convent Settings]
[SELECT] key
ECDIS Keyboard
1. Press the [CHART PLAN] key.
The menu appears in the Information area at the
right side of the screen.
2. Rotate the trackball to place the cursor (arrow
mark) on [SENC Convert Settings] and press the
[SELECT] key.
The [SENC Convert Settings] window appears.
Trackball
1
[Close] button
Check box
3. Check the box on [Automatic SENC conversion]
and [Automatic Display Unit]. (Or confirm that
the check marks are displayed.) To check the
box, place the cursor on the box and press the
[SELECT] key.
4. Place the cursor on the [Close] button and press
the [SELECT] key to close the windows.
2. Loading the catalogue chart to be updated from CD-ROM to ECDIS
1. Insert latest CD-ROM in the CD drive.
2. Press the [CHART PLAN] key to display the
[by CD Catalogue]
D draive
[Load]
[Load] button
menu.
3. Place the cursor on [Load] and [by CD Catalogue],
and press the [SELECT] key to display the [Load
CD Catalogue] window.
4. Confirm that the drive is "D" on the [Load Dir] box.
Place the cursor on the [Load] button and press
the [SELECT] key.
When the catalogue is loaded, the catalogue
name input window appears.
2
5. Place the cursor on an alphabet or number button
and press the [SELECT] key. Repeat this to
enter catalogue name. Set a name which is easy
to understand.
For example, if the issue date of the CD is March
11, 2003, name it as JP20030311. You can
switch between lower case and upper case by
placing the cursor on the [Upper] or [Lower]
button and pressinh the [SELECT] key.
[ＯＫ] button
[YES] button
[Close] button
6. Place the cursor on the [OK] button and press the
[SELECT] key.
Note: If the catalogue name is the same as an
existing one you named previously, the
following message appears. To overwrite the
name, place the cursor on the [Yes] button and
press the [SELECT] key. To change the name,
place the cursor on the [No] button, press the
[SELECT] key and enter a new name.
7. Place the cursor on the [Close] button and press
the [SELCT] key to close the [Load or view CD
Catalogue] window.
[Load or View CD Catalogue] window
3
Loading...