Franklin Fueling Systems Colibri User Manual

8.

00"

6.

3.00"

31"

UIT

R

P

C

E

E E

R

IR R

V E

C O

O

K

E

N F

C

V

T

E

E G

O

P B

VIN

C

H

O

TIG

O

T

E

M

I

E

U

L

R

C

C

R

TECHNICAL

C

IR

E

OU

R

E

O

U

LINE

DV

IR AVALE C

PRESSURE

'

E

N

ER

BULLETIN

LEV

TEST

DISCHARGE/LEAK DETEC TO R

DOWN FOR TEST

RISER/COLUMN PIPE

POINT

(1"

CAL

CENTERLINE

UP FOR SE R VICE

CENTERLINE

NPT

MAK

June 19, 2014 • TB0614-01

)

LINE TEST PO RT

5.80"

11.

00"

Connecting a T5 Series Fuel Management System or Colibri Tank Monitor to

5.

an ALVIC SCS3 Point of Sale System

75"

4.

Overview

94"

3.

31"

This documentexplains how to connect a T5 Series Fuel Management System or ColibriTank Monitor to anALVIC

SCS3 System and allow the ALVIC system to receive inventory informationfrom the T5 Series or Colibri tank monitor.

In applicationswhere dispenser reconciliation is desired, it will also allow the ALVIC system to send sales information

to the T5 Series or ColibriTank Monitor, without the need for a TS-DIMIB(DispenserInterface Module).

Requirements

• T5 Series Controller Module software version 1.8.0.6620 or greater. Colibri version 1.8.3.7080.

Communications

On the ALVIC System, Configuring SCS3 for a Franklin ATG

For the SCS3 to work with Franklin Fueling Systems T5 series and Colibri tank monitors, you needtoconfigure the SCS3.XML file with the following parameters.

<TipoSonda>9</TipoSonda>

Add the following nodes after the <IntervaloStock> <Url>http://192.168.168.168/cgi-bin/tsaws.cgi</Url> //

Replace the IP: 192.168.168.168 with the correct one that corresponds to the console. <UserPwd>admin</UserPwd> //

The parameter admin should only be changed if the administrator password at the tank gauge monitor had been changed from factory defaults, and should be replaced by the new administrator password.

Example: