Franke FTU 3807 WXS 70H, FTU 3807-P WXS 70H, ftu 3807 w xs - in2 Instructions For Use And Installation
Instructions for use and installation
Cooker Hood
FTU 3807 WXS 70H
FTU 3807-P WXS 70H
EN
3
3
Instructions Manual
INDEX
RECOMMENDATIONS AND SUGGESTIONS....................................................................................................................18
CHARACTERISTICS............................................................................................................................................................19
INSTALLATION ....................................................................................................................................................................20
USE.......................................................................................................................................................................................24
MAINTENANCE....................................................................................................................................................................25
EN
118
RECOMMENDATIONS AND SUGGESTIONS
The Instructions for Use apply to several versions of this appliance. Accordingly, you
may find descriptions of indi vidual feat ures t hat do not apply t o your specif ic appli ance.
INSTALLATION
• The manufac turer will not be held liable for any damages res ulting from incorrec t or
improper install ation.
• The minimum safety distance between the cooker top and the extractor hood is 550
mm.
• Check that the mains voltage corresponds to that indicated on the rating plate fixed to
the inside of the hood.
• For Class I appliances, check that the domestic power supply guarantees adequate
earthing.
Connect the extract or t o the exhaust flue throu gh a pipe of minimum diameter 120 mm.
The route of the flue must be as short as possi ble.
• Do not connect the extractor hood to exhaust ducts carrying combustion fumes (boilers, fireplaces, etc. ).
• If the extractor is used in conjunction with non-electrical appliances (e.g. gas burning
appliances), a sufficient degree of aeration must be guaranteed in the room in order to
prevent the backflow of exhaust gas. The kitchen must have an opening communicating directly with the open ai r i n order to guaran t ee the ent ry of cl ean ai r.
USE
• The extractor hood has been designed exclusively for domestic use to eliminate
kitchen smells.
• Never use the hood for pur poses other t han fo r w hich it has ben designed.
• Never leave high naked fl ames under t he hood w hen it is in oper ati on.
• Adjust the flame intensity to direct it ont o the bottom of the pan only, making sure that it
does not engulf the si des.
• Deep fat fryers must be continuously monitored during use: overheated oil can burst
into flames.
• Do not flambè under the range hoo d; risk of fire
• This appliance is not intended for use by persons (including children) with reduced
physica l, senso ry or men tal capa bilities, o r lack of expe rience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for t heir safet y.
• Children should be supervised to ensure that they do not play with the appliance.
MAINTENANCE
• Switch off or unplug t he appliance from the mains supply before carrying out any maintenance work.
• Clean and/or replace the Fi l ters af ter the speci fi ed time peri od.
• Clean the hood using a damp cl oth and a neutral liquid deter gent.
The symbol on the product or on its packaging indicates that this product may not be treated as
household waste. Instead it shall be handed over to the applicable collection point for the recycling of
electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be
caused by inappropriate waste handling of this product. For more detailed information about recycling of
this product, please contact your local city office, your household waste disposal service or the shop
where you purchased the product.
550 mm min.
EN
119
CHARACTERISTICS
Dimensions
Components
Ref. Q.ty Product components
1 1 Hood equipped with: Co ntrols, Lig hts, Filters
3 1 Hood suppor t equippe d with the Exhaust Group
7 1 tube in PVC
8 1 Directioned grid
8c 1 Air outlet reduction ø 120mm
9 1 Reduction flange ø 150-120 mm
Ref. Q.ty Installation components
11 4 Small blocks ø 10
12a 4 Screws 5 x 70
12b 4 Screws M4 x 15
12e 2 Screws 2,9 x 9,5
13 4 Screws plug M4
Q.ty Documentations
1 Instruction booklet
11
12a
3
12b
13
1
9
7
12e
8
8c
Loading...