R3
Installation Guide
R3
Fingerprint Color Door Access &
Time Attendance
Step 1
Determine the Location and Position
of the Installation
• Avoid installing the terminals in locations that have contact with
a strong light source (e.g direct sunlight, spotlight, fluorescent
light, etc)
• Avoid installing the terminals in locations prone to high moisture
or condensation levels in the air
• The recommended installation height of the terminals from the
ground is 1.2 meter.
Step 2
Mounting Terminals
It is recommended that the terminals be mounted to a wall in
to ease the process of enrolment and verification. In a situation
whereby mounting the terminals on a wall is not an option, you
can choose to use flexi kit to convert the terminals to desktop units.
However, there are limited options for the flexi kit and some terminals might not be suitable to be placed on flexi kits.
A. MOUNT ON WALL
• After measuring the height
accordingly and make relevant marking on the wall,
drill the screws into the wall
to secure the back plate.
Step 3
Wiring for Power Supply
The power input ports for this model are located at the rear of the
terminal. There is no adapter plug supplied with the model, you
need to source for power cable (red and black cables) to connect
the power from the terminal to the AdapTec.
TCP/IP
RJ45-1
RJ45-2
RJ45-3
For NC or NO door lock system
_
SEN
BEL
BEL+
RJ45-4
GND
BEEP
NO
BUT
Power Supply
GLED
COM
DC12V
RLED
_
NC
ALM
3rd party controller
with 26 bits
Wiegand output
GND
INWD0
INWD1
+12V
ALM+
3rd party controller
with 26 bits
Wiegand input
WD0
WD1
+12V
GND
RXD
TXD
RS232
GND
cable
485+
GND
_
485
© 2 014 Time tec Compu ting Sdn Bhd . All rig hts rese rved. • 10 2014
• Attach the terminal to the
back plate and tighten the
screws. Refer to Appendix I
for dimensions and measurements of installation.
4 feet / 1.2 meter
(recommended)
1. RS485 Single Connection
485+
RX+
_
485
_
RX
RS232/RS485
Data Converter
2. RS485 Network Connection
485+
485
485+
485
_
_
RX+
_
RX
RS232/RS485
Data Converter
Loading...