Esoteric D-07 User Manual

D01090921B
D-07
D/A Converter - Digital Pre-Amplifier
OWNER’S MANUAL .................... 3
MODE D’EMPLOI .......................15
MANUAL DEL USUARIO ........... 27
2
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is
intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.
IMPORTANT SAFETY INSTRUCTIONS
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Do not block any ventilation openings. Install in accordance with the manufacturer's instructions.
8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
9) Do not defeat the safety purpose of the polarized or grounding­type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.
10) Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point
where they exit from the apparatus.
11) Only use attachments/accessories specified by the manufacturer.
12) Use only with the cart, stand, tripod, bracket, or
table specified by the manufacturer, or sold with
the apparatus. When a cart is used, use caution when moving the cart/apparatus combination
to avoid injury from tip-over.
13) Unplug this apparatus during lightning storms or
when unused for long periods of time.
14) Refer all servicing to qualified service personnel. Ser vicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normally, or has
been dropped.
< Do not expose this apparatus to drips or splashes. < Do not place any objects filled with liquids, such as vases, on the
apparatus.
< Do not install this apparatus in a confined space such as a book
case or similar unit.
< The apparatus draws nominal non-operating power from the
AC outlet with its POWER or STANDBY/ON switch not in the ON
position.
< The apparatus should be located close enough to the AC outlet so
that you can easily reach the power cord plug at any time.
< The mains plug is used as the disconnect device, the disconnect
device shall remain readily operable.
< Products with Class I construction are equipped with a power
supply cord that has a 3-prong grounding plug. The cord of such a product must be plugged into an AC outlet that has a protective grounding connection.
< If the product uses batteries (including a battery pack or installed
batteries), they should not be exposed to sunshine, fire or excessive
heat.
< CAUTION for products that use replaceable lithium batteries: there
is danger of explosion if a battery is replaced with an incorrect type
of battery. Replace only with the same or equivalent type.
< Caution should be taken when using earphones or headphones
with the product because excessive sound pressure (volume) from
earphones or head-phones can cause hearing loss.
WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
CAUTION
< DO NOT REMOVE THE EXTERNAL CASES OR CABINETS TO EXPOSE
THE ELECTRONICS. NO USER SERVICEABLE PARTS ARE INSIDE.
< IF YOU ARE EXPERIENCING PROBLEMS WITH THIS PRODUCT,
CONTACT TEAC FOR A SERVICE REFERRAL. DO NOT USE THE PRODUCT UNTIL IT HAS BEEN REPAIRED.
For U.S.A.
• Reorient or relocate the equipment and/or the receiving
antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
CAUTION
Changes or modifications to this equipments not expressly
approved by ESOTERIC COMPANY for compliance will void the user’s warranty.
ENGLISH
3
For European Customers
Information for Users on Collection and Disposal of Old Equipment and used Batteries
These symbols on the products, packaging, and/or
accompanying documents mean that used electrical and
electronic products and batteries should not be mixed with
general household waste. For proper treatment, recovery and recycling of old products and used batteries, please take them to applicable collection points, in accordance with your national
legislation and the Directives 2002/96/EC and 2006/66/EC.
By disposing of these products and batteries correctly, you will help to save valuable resources and prevent any potential negative effects on human health and the environment which could otherwise arise from inappropriate waste handling.
For more information about collection and recycling of old products and batteries, please contact your local municipality, your waste disposal service or the point of sale where you purchased the items.
Information on Disposal in other Countries outside the European Union
These symbols are only valid in the European Union. If
you wish to discard these items, please contact your local authorities or dealer and ask for the correct method of disposal.
Contents
Thank you for choosing Esoteric. Read this manual carefully to get the best performance from this unit.
Before Use ...........................................................4
Specifications ........................................................4
Identifying the Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
Connection ..........................................................6
Basic Operation ......................................................8
Settings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8
Restoring Factory Default Settings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
Connecting to a Personal Computer
and Playing Back a Music File .................................... 12
Messages ..........................................................14
Troubleshooting ...................................................14
Note for the battery symbol (bottom right two symbol examples):
This symbol might be used in combination with a chemical symbol. In this case it complies with the requirement set by the Directive for the chemical involved.
“Super Audio CD” is a registered trademark. “DSD” is a registered trademark.
Microsoft, Windows Media, Windows and Windows Vista are either
registered trademarks or trademarks of Microsoft Corporation in the
United States and/or other countries.
Before Use
Specifications
What’s in the box
Please confirm that the following accessories are in the box when you
open it.
Power cord x 1 Owner’s manual x 1 Warranty card x 1
Read this before operation
< Place the unit in a stable location near the audio system that you
will use.
< Be careful to avoid injury when moving the unit due to its weight.
Get someone to help you if necessary.
< As the unit may become warm during operation, always leave
sufficient space around the unit for ventilation. Make sure there is at least 20 cm (8”) of space above and at least 5 cm (2”) of space on each side of the unit. Do NOT place anything such as a CD, CD-R,
LP, cassette tape etc. on top of the unit.
< The voltage supplied to the unit should match the voltage as
printed on the rear panel. If you are in any doubt regarding this matter, consult an electrician.
< Choose the installation location of your unit carefully. Avoid placing
it in direct sunlight or close to a source of heat. Also avoid locations
subject to vibrations and excessive dust, heat, cold or moisture.
< Do not open the cabinet as this will void your factory warranty
and might result in damage to the circuitry or electrical shock. If a foreign object should get into the unit, contact your dealer or Esoteric authorized service company.
< When removing the power plug from the wall outlet, always pull
directly on the plug, never yank on the cord.
< Keep this manual in a safe place for future reference.
Audio output (Analog Audio)
Jacks . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . XLR (2 channel) x 1
RCA (2 channel) x 1
Output impedance ......................................XLR: 100 Ω
RCA: 100 Ω
Maximum Output level (1 kHz, full scale, 10 kΩ) .......XLR: 2.2 Vrms
RCA: 2.2 Vrms
Frequency response .................................5 Hz to 40 kHz
Signal-to-Noise Ratio (S/N). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 130 dB
Total harmonic distortion ............................0.001% (1 kHz)
Digital audio input
Balanced digital input . . . . . . . . . . . . . . . . . . . . . XLR (5.0 Vp-p/110 Ω) x 1
Coaxial terminal ............................RCA (0.5 Vp-p/75 Ω) x 2
Optical digital terminal . . . . . OPTICAL (–24.0 to –14.5 dBm peak) x 1
USB port . . . . . . . . . . . . . . . . . . . . . . . B connector, USB 1.1 Full Speed x 1
Input sampling frequencies
XLR*, RCA, OPTICAL . . . . . . . .32, 44.1, 48, 88.2, 96, 176.4, 192 (kHz)
USB . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32, 44.1, 48, 88.2, 96 (kHz)
* Only the XLR terminal can receive DSD signals when
connecting with an Esoteric P-05 CD/SACD transport. (The
Esoteric P-05 is an optional component not included with this device).
Word Synchronization output
Jack . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .BNC x 1
Output frequencies
44.1, 88.2, 176.4, 48, 96, 192 (kHz/ rectangular wave)
Output level .........................Equivalent to TTL levels (75 Ω)
Word Synchronization input
Jack . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .BNC x 1
Input frequencies
44.1, 88.2, 176.4, 48, 96, 192, 100 (kHz/ rectangular wave)
Input impedance ..............................................75 Ω
Input level ...........................Equivalent to TTL levels (75 Ω)
General
Power supply
Europe model ...................................AC 230 V, 50 Hz
U.S.A./Canada model ............................AC 120 V, 60 Hz
Korea model . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . AC 220 V, 60 Hz
Power consumption ............................................7 W
External dimensions (W x H x D)(including protrusions)
442 x 103.5 x 346 mm (17 3/8” x 4 3/4” x 13 5/8”)
Weight ..............................................9.5 kg (20.9 lb)
Operating temperature ..............................+5°C to +35°C
Operating humidity . . . . . . . . . . . . . . . . 5 % to 85 % (no condensation)
Storage temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . –20°C to +55°C
Accessories
Power cord x 1 Owner’s manual x 1 Warranty card x 1
< Design and specifications are subject to change without notice. < Weight and dimensions are approximate. < Illustrations may differ slightly from production models.
4
Identifying the Parts
B
A
C
D
E
F
G
ENGLISH
A
POWER
Use this button to turn the unit on and off.
The indicator ring lights when the unit is ON.
B
WORD
Displays the current word sync or master clock status (see page 10).
C
MENU
Press to engage the setup mode (see page 8).
D
Remote control sensor
Receives signals from the remote control unit. Point the remote control unit at this sensor when using the remote control. You can use the P-05 remote control.
E
DISPLAY
Displays the current input, sampling frequency, etc.
F
INPUT
Switches digital input source. Select the terminal to which a digital device is connected. The display flashes when no digital signal is being input.
< The INPUT buttons (</>) on an Esoteric P-05 remote control can
also be used.
G
VOLUME
The volume level can be adjusted from –∞ (MUTE), –99.5 to 0dB. Use these buttons to adjust the volume when connected directly
to a power amplifier.
When a preamplifier is connected, set the volume to 0.0. When in the set-up mode, these buttons are used to select the
menu item for setting.
< The VOLUME buttons (–/+) on the P-05 remote control can also be
used.
When using the P-05 remote control to operate this unit, set “RC”
(Remote control) to “Enable” (see page 10).
5
Loading...
+ 11 hidden pages