Epson TM-J9000, TM-J9100 Important Initial Ink Charging Instructions

405075201

Important Initial Ink Charging Instructions

1. Peel away the 3 pieces of tape and remove the spacer from the slip paper path.

2. Make sure the printer is on.

3. Open the roll paper cover and insert the roll paper; then close the cover.

4. Open the ink cartridge cover.

5. Take the new cartridge out of its packing and remove the yellow tape.

6. Note: You must not remove any tape on which the EPSON logo is printed.

7. Insert the cartridge firmly but gently as far as it will go until it clicks into place. For the two­color model, you need to insert two separate ink cartridges.

8. Close the cover.

Note:
The printer takes about 1 minute to charge the ink. The POWER LED flashes during this
operation. Be sure not to turn off the power or open the printer cover while the POWER LED is
flashing.

When the initial ink charging is finished, the POWER LED stays on.
For full instructions, see the User’s Manual.

Attaching the Feeder Guide

Feeding paper using the included feeder guide
allows you to insert a check straight. Also, the
auto sheet feeder (ASF) model printers can
feed up to 25 checks without manual feeding.
Follow these steps to attach the feeder guide.

1. Hold the edge of the feeder guide
carefully.

2. Insert the dowels of the feeder guide into
the holes on the feeder guide; then move it
down until it stops in place.

Dowel of the
feeder guide

➀

➁

Attaching the Pocket

A pocket is provided with each auto sheet
feeder (ASF) model printer. Follow the steps
shown below to attach the pocket.

1. Push down the pocket cover on the left of
the printer, and remove it.

Note:
To attach the cover again, insert the cover
while pushing it up.

2. Make sure that the ejection lever is open. If it is closed, open it.

The ejection lever is open. The ejection lever is closed.

Note:
Be careful not to hurt your fingers on the lever edge.

(only for the ASF model)

3. Position the pocket as shown in the picture below, and push it into the printer until it clicks
in place.

➀

➁

Insert the hooks on the four corners of the
pocket into the holes indicated with the
circles, and move the pocket into place.

4. Unfold the stopper of the pocket as shown in the following picture.

Stopper

Note:
To remove the pocket, place the printer vertically as shown in the picture below; then while
pushing up the lever on the bottom of the pocket, slightly push the pocket backward, and then
pull it up.

➀

➁

Push up the lever.

Copyright © 2004 by Seiko Epson Corporation

Printed on Recycled Paper

Printed in China 2004.08