Epson STYLUS PHOTO R300, STYLUS PHOTO R300M User Manual

EPSON Stylus®Photo R300 Series

Start

Here

EPSON Stylus Photo R300 Series

1 Remove everything from the box.

Unpack

CPD-17016 4044644-00 XXX

Small CD

insert

Ink cartridges

Quick Reference

Preview Monitor

(included with EPSON

Stylus Photo R300M only)

2 Remove all the tape and

packing material from the printer.

Printer

CD/DVD Tray

Preview Monitor Base (included with EPSON

Stylus Photo R300M only)

CD position

check paper

Printer Software

CD-ROM

User’s Guide

3 Open the output tray and lift the printer cover.

Then remove the tape.

Make sure the CD/DVD tray guide is closed completely.

Make sure the

tray guide is up

continue

If you have the EPSON Stylus Photo R300M, you need to attach the preview monitor.

1 Unscrew the cap from the end of the screw on the base. Then remove the screw.

Unscrew cap

2 Position the monitor into the base as shown, lining up the holes for the screw.

Place monitor

in base and

line up holes

3 Push the screw through the holes (it can fit only one way) and screw the cap back onto the

end of the screw.

Remove screw

4 Remove the plastic cover from the printer.

Remove cover

5 Insert the tabs on the monitor base into the slots on the printer.

Attach monitor

base to printer

Connect to preview monitor port

6 Remove the cap from the end of the monitor cable, then connect it to the preview monitor

port on the back of the printer.

1 Plug the printer’s power cord into a grounded electrical outlet.

Turn On the Printer

STOP: Do not connect the printer to your computer yet. Wait until you are instructed to connect the USB cable in section 5, “Install Software.”

2 Press the power button

to turn on the printer.

CAUTION: Never use an external switch, such as a wall switch or power strip switch, to turn the printer on or off.

continue

+ 4 hidden pages