Epson Expression Home XP-446 Getting Started Guide

XP-340/XP-440/XP-446

Turn on and configure

Start Here

Read these instructions before using your product.

Note for Spanish speakers/Nota para hispanohablantes: Para

obtener instrucciones de conﬁ guración en español, consulte la Guía de instalación en www.epson.com/support/xp340sp,

www.epson.com/support/xp440sp o www.epson.com/support/xp446sp (requiere una conexión a Internet).

Unpack

Note: Do not open ink cartridge packages until you are ready to install

the ink. Cartridges are vacuum packed to maintain reliability.

1 Remove all protective materials from the product.

1 Connect the power cord to the back of the product and to

an electrical outlet.

Caution: Do not connect to your computer yet.

2 Raise the control panel and turn on the product.

Caution: Do not lower the control panel without ﬁ rst squeezing the

release bar underneath or you may damage the product.

3 Press or to select your language, then press OK.

Note: You can change the language later using the product’s

control panel. For more information, see the online User’s Guide.

2 Lift up the scanner unit and remove all protective materials

from inside the product.

Caution: Do not touch the ﬂ at white cable.

3 Lower the scanner unit.

Install ink cartridges

Caution: Keep ink cartridges out of the reach of children and do not

drink the ink.

1 Lift up the scanner unit.

Caution: Do not touch the ﬂ at, white cable.

2 Gently shake the ink cartridges.

3 Unpack the ink cartridges.

4 Remove only the yellow tape from each ink cartridge.

Caution: Do not remove any other labels or seals, or ink will leak.

Do not touch the green chip on the cartridge.

5 Insert the cartridge in the holder for each color. Press each

cartridge down until it clicks. Make sure all cartridges are pushed down into place.

6 Lower the scanner unit, then press to start charging the

ink delivery system.

2 Slide the edge guide to the left.

3 Slide out the output tray.

4 Load paper, glossy or printable side up and short edge ﬁ rst,

against the right side of the rear paper feed slot.

7 The printer starts charging the ink. Ink charging takes

approximately 4 minutes. When you see a completion message on the printer’s LCD screen, charging is complete.

Caution: Don’t turn off the printer while it is charging or you’ll

waste ink.

Note:

• The printer is designed for use with Epson third-party cartridges or ink.

• The cartridges included with the printer are designed for printer setup and not for resale. After some ink is used for charging, the rest is available for printing.

Load paper

cartridges only, not

1 Make sure the product is done charging ink. Then ﬂ ip the

feeder guard forward, raise the paper support, and tilt it backwards slightly.

5 Slide the edge guide against the paper, but not too tightly,

and ﬂ ip the feeder guard back.

Note: Make sure you place the paper against the right side of the

rear paper feed slot. Otherwise, the printer cannot detect the paper and the paper setup screen is not displayed on the control panel.

6 Check the current paper settings on the control panel.

To use these settings, press OK. If you want to change the settings, press Select the paper size, press OK, select the paper type, press OK, then press OK again to conﬁ rm settings.

or to select Change, then press OK.

+ 2 hidden pages