Electrolux EWT 719 Instruction Book
WASHING MACHINE
INSTRUCTION BOOK
EWT 719
146 4978 01 - 10/03
GB
2
CONTENTS
FOR THE USER
WARNINGS .................................................. 3
Usage ........................................................... 3
Precautions against frost .............................. 3
Scrapping ...................................................... 3
Protection of the environment ....................... 3
WASHING MACHINE DESCRIPTION ......... 4
The detergents dispenser ............................. 4
The control panel .......................................... 4
How to do a wash ? ...................................... 5
Loading the washing ..................................... 5
Proportioning of detergents .......................... 5
Choice of the required program .................... 5
Choice of the spinning speed ....................... 5
Choice of the required option ........................ 5
«Prewash / Heavy stains» pushbutto ............ 5
«Quick wash» pushbutton ............................ 5
«Rinse Plus» pushbutton .............................. 5
«Spinning» pushbutton .................................. 5
Starting the program ..................................... 5
Action during a program ............................... 6
Adding of laundry .......................................... 6
Modifying the current program ...................... 6
Cancelling the program ................................. 6
End of program ............................................. 6
PROGRAMS TABLE .................................... 7
WASHING GUIDE ........................................ 8
Sorting and preparing your washing ............. 8
Washing load depending on the nature
of the material ............................................... 8
Detergents and additives .............................. 8
International symbols for care of textiles ...... 9
CARE AND CLEANING ............................. 10
Descaling the washing machine ................. 10
The surface................................................. 10
The detergents dispenser ........................... 10
The drain filter ............................................. 10
OPERATING PROBLEMS ......................... 11
AFTER SALES SERVICE .......................... 12
FOR THE INSTALLER
WARNINGS .................................................13
Technical characteristics .............................13
INSTALLATION .........................................14
Unpacking ....................................................14
Position ........................................................14
Moving your washing machine ....................14
Leveling .......................................................14
Water inlet ....................................................14
Drain ............................................................15
Electrical connection ....................................15
3
A. FOR THE USER
1. WARNINGS
Keep this user’s manual with your washing machine. If you sell your washing machine or give it away, make sure that
it is accompanied by its user’s manual. The new user can then be informed of how the washing machine operates
and read relevant warnings.
These warnings have been written for your safety and for the safety of others. Please read these comments
carefully before installing and using your washing machine. Thank you for your attention.
1.1. Usage
• When you receive your washing machine, unpack it
or have it unpacked immediately. Check its general
appearance. Make any reserves in writing on the
delivery form and keep a copy.
• Your washing machine was designed for use by
adults. Make sure that children do not touch it or
use it as a toy.
• Do not modify or attempt to modify the characteristics of this washing machine. This could be dangerous for you.
• Your washing machine is intended for normal
domestic use. Do not use it for commercial or
industrial purposes or for any purpose other than
that for which it was designed : to wash, to rinse
and to spin.
• Unplug the power suplly plug and close the water
supply tap every time after using your washing
machine.
• Only wash articles that can resist machine
washing. Refer to the instructions on the label for
each article.
• Do not wash underwear with bones, or any material
without hems, or torn materials in your washing
machine.
• Remember to remove all coins, safety pins, boraches, screws, etc., before each wash. They can
cause serious damage if they are left in your
washing.
• Do not put articles in your washing machine if you
have used a solvent, alcohol, trichloroethylene, etc.,
to remove stains from them. If you must use these
stain removers, wait until the product has evaporated before putting the articles in the drum.
• Collect all small articles such as socks, belts, etc.,
in a small cloth bag or pillow case.
• Use the quantity of detergent indicated in the «proportioning of detergents» section.
• Always unplug the washing machine before cleaning it and doing any maintenance.
1.2. Precautions against frost
If your washing machine is exposed to temperatures
below 0°C, take the following precautions :
• Close the tap and disconnect the water supply pipe.
• Put the end of this pipe and the drain pipe into a
bowl on the floor.
• Select the «Drain» programme and make sure it
works until it is complete.
• Switch the washing machine off by putting the program selector to the «Off»
*
position or pressing on
the «On/Off»* key.
• Unplug the washing machine.
• Screw in the water inlet pipe and install the drain
pipe.
Water that remained in the pipes will then be evacuated, thus preventing the formation of frost or ice that can
damage your washing machine.
The next time you want to use your washing machine,
make sure that it is installed in a room in which the temperature is above 0°C.
1.3. Scrapping
All materials marked with the symbol can be recycled. Put them in a waste tip (ask for information from
your municipal offices) so that they can be recovered
and recycled.
When you take your washing machine to the tip, make
sure that everything that could be dangerous is out of
service ; cut the power supply cable flush with the surface of your washing machine.
1.4. Protection of the environment
We recommend that the following instructions should
be followed to achieve savings in water and energy and
therefore to contribute to protection of the environment:
• If possible, use the washing machine at full capacity
rather than with partial loads (however, do not overload the drum).
• Only use the Prewash or Soak function for very
dirty washing.
• Use a detergent dose adapted to the water hardness (see «proportioning of detergents» section)
and to the amount of washing and how dirty it is.
*depending on model
4
2. WASHING MACHINE DESCRIPTION
1 - Control panel
2 - Lid opening handle
3 - Leveling screws
4 - Filter door
5 - Lever for moving the washing machine
2.1. The detergents dispenser
Symbols
1 - prewash 3 - softener
(do not exceed the MAX mark)
2 - wash 4 - softener overflow (if overfilled)
2.2. The control panel
1 - «Prewash / Heavy Stains» pushbutton 5 - «Spin» pushbutton
2 - «Quick Wash» pushbutton 6 - Program and information display lights
3 - «Rinse Plus» pushbutton 7 - Program selector
4 - «Start/Pause» pushbutton
3
1
2
4
5
3
1
4
2
1
3
4
6
7
2
5
5
3. HOW TO DO A WASH ?
Before the first wash in your washing machine, we recommend that you should do a preliminary wash at
90°C with detergent but without any washing to clean
the tub.
3.1. Loading the washing
• Lift the machine cover.
• Open the drum by pressing on the locking button A;
the two flaps automatically separate.
• Insert the washing, close the drum and the cover of
your washing machine.
Warning : before you close
the cover of your washing
machine, make sure that the
drum door is properly closed:
•the two flaps latched
together,
•the locking button A extended.
3.2. Proportioning of detergents
Your washing machine was designed to reduce water
and detergent consumption, therefore reduce the doses recommended by detergent manufacturers.
Pour the powder detergent dose into the wash compartment and into the prewash compartment if
you chose the «prewash» option. Pour in the softener
into the compartment if you wish.
If you are using a different type of detergent, refer to the
«detergents and additives» section in the washing guide.
3.3. Choice of the required program-
me
The programmes table will tell you which is the appropriate programme for your washing type (see § 4).
Put the programme selector
onto the required programme ; the lights corresponding to the phases making
up the programme will light
up.
3.4. Choice of the required option
The various options
should be chosen after
the programme has been
displayed and before
pressing the Start/Pause
pushbutton.
Press the required pushbutton(s) ; the corresponding
lights come on. When you press again, the lights go off.
When one of these options is not compatible with the
chosen programme, the corresponding light will flash
for a few seconds (see programme table).
3.4.1. «Prewash / Heavy Stains» pushbutton
This pushbutton allows to choose between two functions :
• «Prewash» function :
The washing machine does a prewash at 30°C
maximum. The prewash finishes with a brief spinning
for cotton and synthetic programs, and by a draining for
delicates programs.
• «Heavy Stains» function :
This option reinforces the washing action. You can add
stain removal salts into the prewash compartment in
your washing machine.
3.4.2. «Quick wash» pushbutton
If you select this function, the wash time is reduced
depending on which program you chose.
3.4.3. «Rinse plus» pushbutton
This option adds two rinses on Cotton, Synthetics and
Delicates programmes. It is advised for allergic people
to detergent products and in areas with fresh water.
3.4.4. «Spinning» pushbutton
The maximum spin speed is defined as a function of the
type of washing and depending on the selected programme.
However, you can reduce the speed or choose the rinse hold*, silence cycle*, drain*, or spinning suppression* positions.
3.5. Starting the program
After you chose the washing program, press
the Start/Pause pushbutton to start the cycle. The corresponding light stays on.
It is normal that the program selector does
not turn during the cycle.
A
* depending on model
Loading...