Dyson Airblade V Installation Guide

Free 5 year guarantee
Register your guarantee at www.dysonairblade.com

Installation Guide

IMPORTANT SAFETY INSTRUCTIONS

READ BEFORE PROCEEDING FURTHER.

Retain for future use.

WARNING

All electrical installation and repair work should be carried out by a qualified electrician or
Dyson Service Engineer in accordance with current local codes or regulations.

WARNING

Risk of electric shock! If casing is removed or handled improperly the internal components of the
unit may cause harm or become permanently damaged.

BEFORE INSTALLATION

Before beginning any installation work you must confirm the following.

WIRING

• Check that the electrical supply corresponds to that shown on the rating plate. If the unit is connected
to any electrical supply other than stated on the rating plate of the unit, permanant damage or
improper/unsafe operation of the hand dryer may result.

• A means for all-pole disconnection must be incorporated into fixed wiring, in accordance with
national and local wiring regulations.

• The unit must be earthed.

• When connecting the unit to the electricity supply use cable in accordance with national and local laws

and applicable codes and standards, including fire-rated construction.

• If cable entry is to be from the side, it must be secured using plastic or flexible metal conduit and
suitable fittings that lock to the side bracket.The conduit and fittings must be in accordance with local
and national regulations. Solid metal conduit is not suitable.

• Ensure that the conduit and wires are long enough to connect to the backplate and the terminal block.

• When wiring in the back plate the maximum length for the wire’s insulation to be stripped back

is6mm.

LOCATION

• The unit is designed for dr y, internal location only.

• Consult local and national accessibility codes and regulations for relevant installation guidelines.

Conformity and compliance is the responsibility of the installer.

• Ensure the required electrical supply is available for later connection.

• This product is not suitable for mounting onto porous wall sur faces (e.g. plaster) without a back panel,

to avoid discolouring or damage to unprotected walls. (The recommended back panel for this product
is available from Dyson.)

IMPORTANT

• Please refer to the Dyson Owners Manual for details of the guarantee.

SAFETY

• Isolate the power before installation.

INSTALLATION

• Make sure that the unit is installed in compliance with all building codes and/or regulations.

• The unit must be mounted on a flat vertical wall capable of supporting the full weight of the unit.

• Use fixings as specified in this installation guide.

• Ensure no pipe work (gas, water, air) or electrical cables, wires or ductwork are located directly behind

the drilling/mounting area.

• Dyson recommends the use of protective clothing, eyeware and materials when installing/repairing as
necessary.

• To avoid damage to the fascia surface during installation, store the fascia in the original packaging
until it is needed.

2

3