SinePower Accessory MCR9
21
A
B
Inverter Remote
1
2
Push
On / Off
SinePower Accessory
The remote control MCR9 is suitable to switch on/off the
following inverters via the “Remote Port II” (also see the
operating manual for the inverter):
• MSI912, MSI 1812T
Displays
The red LED (fig. 1 1) on the front panel displays the
following conditions:
• Constant glow: The inverter is switched on.
• Quick flashing: The inverter is switched on by
positive battery voltage.
• Slow flashing: The inverter is switched off by
positive battery voltage.
Connect
➤ Insert one side of the RJ-11-cable in the socket “To
inverter” (Fig. 2 2).
➤ Insert the other side of the RJ-11-cable into the “Remote
Port II” of the inverter.
Switched on/off by an external signal
The remote control enables the optimal switching on/off of
the inverter by an external signal:
➤ Loosen both Phillips screws and take off the cap
(fig. 2 1).
2
3
4
1
➤ Set the desired connection on the jumper (fig.2 3):
–Jumper open (A): The inverter is switched on by
positive battery voltage
When a plus-signal is present on the control cable, the
inverter is switched on.
– Jumpers are connected (B): The inverter is switched
off by positive battery voltage
When a plus-signal is present on the control cable, the
inverter is switched off (suitable e.g. for roof air
conditioners). If no signal is received, then the inverter
works in the previously activated function.
➤ Mount the cap (fig. 2 1).
A
➤ Connect the control cable (12 V or 24 V) at the (fig. 1 4)
Operation
➤ With the “Push” button (fig. 1 2) switch the inverter on
CAUTION!
The control cable has to be secured by a suitable
fuse (≤ 1A).
remote control connection
or off.
Dometic Australia Pty. Ltd.
1 John Duncan Court
Varsity Lakes QLD 4227
www.dometic.com
4445102065 10/2016