Dlink DWL-7000AP User Manual

This product can be set up using
any current web browser, i.e.,
Internet Explorer 6 or Netscape
Navigator 6.2.3 or later.

DWL-7000AP

D-Link AirXpert

Tri-mode Dualband Wireless

Access Point

Before You Begin

The default IP address for the DWL-7000AP is 192.168.0.50 with a Subnet Mask of

255.255.255.0. Y ou will need to assign your computer a Static IP address within the
same range as the DWL-7000AP’s IP address for the purpose of configuring the DWL­7000AP. See the Manual on the CD-ROM if you need assistance in assigning a

Static IP address for your network adapter.

Check Your Package Contents

DWL-7000AP Wireless Access Point

CD-ROM (containing Manual and Warranty)

TM

Ethernet (CAT5 UTP/Straight-Through) Cable

5V 2.5A DC Power Adapter

If any of the above items are missing, please contact your reseller.

©2003 D-Link Systems, Inc. All rights reserved. Trademarks or registered trademarks are the property of their respective holders. Software and

specifications subject to change without notice. DWL-7000AP . 06192003

Using a power supply
with a different voltage
rating will damage and void
the warranty of this product.

1

Connecting The DWL-7000AP To Your
Network

A. First, connect the power adapter to the receptor at the back panel of

the DWL-7000AP and then plug the other end of the power adapter
to a wall outlet or power strip. The Power LED will turn ON to indicate
proper operation.

B. Insert an Ethernet crossover-cable into the LAN port on the back panel

of the DWL-7000AP and an available Ethernet port on the network

adapter in the computer you will use to configure the DWL-7000AP. The

Link LED for the LAN Port will illuminate to indicate a proper connection.

C. Computers with 802.11a/b/g wireless adapters can connect to the

DWL-7000AP . The DWL-AG650 AirXpert Wireless Cardbus Adapter and
the DWL-AG520 AirXpert Wireless PCI Adapter will connect, out of the
box, with the DWL-7000AP, using their default settings.

C. Antennas

Used to wirelessly

connect to 802.1 1a/b/g

adapters.

Pressing this button restores

the Router to its original factory

B. LAN PORT is for

connecting to a switch

on the local network

with an ethernet cable

2

Reset Button

default settings.

A. Receptor for

Power Adapter.

When you have completed
the steps in this Quick

Installation Guide, your
connected network should
look similar to this:

Using The Setup Wizard

Open your Web
browser and type

“http://192.168.0.50”

into the URL address
box. Then press the
Enter or Return key.

The logon pop-up
screen will appear.

T ype “admin” for the
username and leave the
password field blank.

Click OK

3